Kyocera FS-1350DN 120V FS-1350DN Operation Guide (Basic) - Page 75
Paper path error, Print overrun, Press GO, Auto Error Clear, Toner low, Unknown toner
View all Kyocera FS-1350DN 120V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Message Paper path error Print overrun Press GO RAM disk error## Press GO Replace toner Clean printer Toner low Unknown toner installed USB memory err## Press GO Use alternative? Cassette 1 Wrong ID Wrong Password Corrective Action When one or more optional feeders are installed, this message will appear if any of the paper feeders or the printer cassette upper than the selected one is not properly closed. The print job transferred to the printer was too complex to print on a page. Press [GO] to resume printing. (A page break may be automatically inserted in some places.) You can abandon printing by pressing [Cancel]. If Auto Error Clear is set to On, printing will be automatically resumed after a preset period of time. A RAM disk error has occurred. Look at the error code given in place of ## and refer to Storage Error Codes on page 5-8. To ignore the RAM disk error, press [GO]. Toner has run out in the toner container. Replace the toner container using a new toner kit. The printer does not operate when this message is displayed. Replace the toner container using a new toner kit. Displayed when the installed toner is not the original Kyocera product. Install original Kyocera toner. An error has occurred in the USB flash memory. Look at the error code given in place of ## and refer to CompactFlash (CF) Card and USB Flash Memory Errors on page 5-8. To return the printer to the print-ready status, press [GO]. When the cassette does not contain any paper that matches the print data (paper size and type), this message allows you to specify an alternative cassette to use instead. A paper source number is only displayed when an optional paper feeder is installed. To print from a different paper source, refer to Paper Feed Mode (Setting the paper feed source) section in the Advanced Operation Guide. The ID or Password entered for the Security or Administrator function is not correct. Check the ID or Password. For more information, refer to Security section and Admin (Administrator settings) section in the Advanced Operation Guide. The password does not match the password set. Enter the correct password. For more information, refer to Security section and Admin (Administrator settings) section in the Advanced Operation Guide. Troubleshooting 5-7