Kyocera FS-1370DN KM-NET Viewer Operation Guide Rev-5.2-2010.10 - Page 55
Communication Timeout, SNMP Communication Retries, Secure Protocol Settings, Login Settings
UPC - 632983018170
View all Kyocera FS-1370DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Communication Settings these logical printer ports must match the port number entered in Communication Settings. A restart may be required for logical printer changes to take effect. Use the reset page in the Command Center Basic tab. Note: In older models, set the port number from the device home page. Select Networking > Logical Printers. To restart, select General > Reset. Communication Timeout Enter the number of seconds the server should wait for the printing device to respond to an SNMP or SOAP request. The available range is from 5 to 120 seconds. SNMP Communication Retries Enter the number of times, after an initial failure, the application should attempt to establish SNMP communication with the printing device. The available range is from 0 to 5 retries. A higher number will increase network traffic, while a lower number can improve performance. Secure Protocol Settings Secure Sockets Layer (SSL) is a cryptographic protocol that provides security for network communications. SSL support varies by network interface model. Select SSL to use HTTPS for device communication. Clear SSL to use HTTP for device communication. Login Settings The Login section lets you set user login information. The feature can be set if at least one selected device supports the User Login feature. For an account device, select whether to use Apply same user information as Device Management (available when user information is stored in Communication Settings) or Use another user's information. If Use another user's information is selected, enter the Login user name and Password for the device. For some models, select whether to use local or device authentication. Account Polling Settings Printing devices are interrogated at specific intervals to check for account counter information. When a device is selected from an Accounting Devices View, the following polling mode is provided. Account counter polling Information is gathered about the counters for each account, including total number of prints, copies, fax, scans, page sizes, duplex pages, and pages per sheet. Select an interval, a day or date, and time of day. KMnet Viewer 5-2