Kyocera FS 1800 FS-1800/3800 Installation Manual Rev 1.3 - Page 2
Table of Contents, Adding Paper to the Paper Cassette and MP Tray - waste bottle
UPC - 632983001028
View all Kyocera FS 1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the HP PCL 6. The emulation mode can be changed by following the procedures described in the User's Manual contained as an electronic file in the CD-ROM supplied with the printer. Notice The information in this manual is subject to change without notification. Additional pages may be inserted in future editions. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition. No responsibility is assumed if accidents occur while the user is following the instructions in this manual. No responsibility is assumed for defects in the printer's firmware (contents of its read-only memory). This manual, any copyrightable subject matter sold or provided with or in connection with the sale of the page printer, are protected by copyright. All rights are reserved. Copying or other reproduction of all or part of this manual, any copyrightable subject matter without the prior written consent of Kyocera Mita Corporation is prohibited. Any copies made of all or part of this manual, any copyrightable subject must contain the same copyright notice as the material from which the copying is done. This Installation Manual is applicable to the FS-1800/FS-3800 and the FS-1800N/FS-3800N, which is equipped with a network card as standard. Explanations are given using the FS-1800/FS-3800 throughout this manual and remarks are given accordingly where details are different for the FS-1800N/FS-3800N. For details concerning the network when using the FS-1800N/FS-3800N, refer to the supplied Network Manual. Table of Contents STEP 1 Unpacking 1 STEP 2 Positioning the Printer 2 STEP 3 Installing the Toner Container 3 STEP 4 Installing the Waste Toner Bottle 5 STEP 5 Connecting the Printer to the Computer 7 STEP 6 Connecting the Power Cord 9 STEP 7 Adding Paper to the Paper Cassette and MP Tray....... 10 STEP 8 Turning the Power Switch On 17 STEP 9 Printing a Status Page 18 ©2000-2003 by KYOCERA CORPORATION/KYOCERA MITA CORPORATION All rights reserved. Revision 1.3 January 2003