Kyocera FS-2100DN FS-2100DN/4100DN/4200DN/4300DN Operation Guide - Page 264

Message Print overrun. Troubleshooting Corrective Action The data transferred to the printer was too complex to print on a page. Press [OK] to resume printing. RAM disk error. Press [OK]. ## Registered numbers exceeded. Cannot add. A RAM disk error has occurred. Look at the error code given in place of ##. The possible error codes and their descriptions are as follows. 02: RAM Disk Mode is set to Off. Set the setting to On. Refer to RAM Disk Mode (Setting the RAM disk) on page 4-82. 03: The RAM disk is write protected using command operation. Remove the write protection using the command. 04: No disk space. Purge unnecessary files or increase the RAM disk size. For more information, refer to RAM Disk Size (RAM disk size setting) on page 4-82. 05: The desired file does not exist in the RAM disk. Stored the file in the RAM disk. 10: The file stored in the RAM disk is write protected using command operation. Remove the write protection using the command. There are already 100 accounts registered so it is not possible to register any new accounts. Replace MK. Replace Maintenance Kit which is displayed on the message display. Replacement of the maintenance kit is necessary at every 500,000 images of printing (or every 300,000 images on FS-2100D/FS-2100DN) and requires professional servicing. Replace the toner. Toner has run out in the toner container. Replace the toner container using a new toner kit. The printer does not operate when this message is displayed. Restricted by Job Accounting. Press [OK]. This message is displayed when printing was attempted, despite the Job Account function being on with Restriction applied as the job limit for each job account. To return the printer to the print-ready status, press [OK]. For more information, refer to Job Account.Set. (Job Account setting) on page 4-121. 8-14