Kyocera FS-2100DN Kyocera Command Center RX User Guide Rev-1.60 - Page 70
Advanced > Management > Authentication > Network User Property, Obtain Network User Property
View all Kyocera FS-2100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Settings Pages 6-46 Enter the host name of the Windows domain controller when Network Authentication is specified as Authenticate Mode. Port Number Use the numeric keypad to type the port number when the Server Type below is Ext(ernal). Server Type This specifies the authentication method used by the domain controller when Network Authentication is enabled. Select NTLM when the domain controller is Windows NT, Kerberos for Windows 2000 Server or Windows Server 2003, or Ext(ernal). Domain Name When Network Authentication is enabled, enter up to 10 domain names. You can select one of these domains at login. Select the Default radio button to the left of a domain name which you want to make the default domain. Note: The default domain should be the one which belongs to the host specified in Host Name. Keyboard Login This determines whether login authentication is allowed via the machine operation panel or not, despite the IC card authentication is activated (using the IC card authentication kit installed). Advanced > Management > Authentication > Network User Property This allows to obtain user information at authenticating the user over the network. The LDAP protocol must be enabled in order to obtain user information. Obtain Network User Property Turned On to obtain user information. LDAP Server Name Specifies a host name or IP address for the LDAP server. LDAP Port Number Specifies a port number for LDAP or use the LDAP default port 389. Search Timeout Specifies a period of time for searching the LDAP server. LDAP Security Selects the type of encryption according to the type of security employed by the LDAP server. Select Off when encryption is not used. Authentication Type Selects either the Simple or SASL for the authentication type. Name 1 (2) Specifies the LDAP attribute to obtain a user name for display, from the LDAP server. The default for Name 1 is displayName. E-mail Address Specifies the LDAP attribute to obtain an E-mail address from the LDAP server. The default is mail. User Guide