Kyocera FS-3900DN FS-2000D/3900DN/4000DN Operation Guide Rev-1.2 (Advanced Edi - Page 57
Changing Serial Interface Parameters, Interface, Parallel, Serial
UPC - 674983006900
View all Kyocera FS-3900DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Using the Operation Panel 8 Press ? or @ to scroll through the following communication modes: • Nibble (high) • Auto • Normal • High speed 9 When the desired communication mode is displayed, press [OK]. 10 Press [Menu] to exit the menu selection. Changing Serial Interface Parameters NOTE: This section applies to the printer having the optional serial interface board kit (IB-11) installed. You can confirm or change the serial interface parameters including baud rate, data bits, stop bits, parity, and protocol. These parameters must match those of the computer's serial interface. 1 Press [Menu]. 2 Press ? or @ repeatedly until Interface > appears. 3 If the interface is other than serial, press [OK]. A blinking question mark (?) appears. Interface ? Parallel 4 Press ? or @ repeatedly until Serial appears. Interface ? Serial 5 Press [OK] again. 6 Press B. One of the following serial parameters is indicated (Baud rate for example). ADVANCED OPERATION GUIDE 2-31