Kyocera FS-9500DN FS-9100/9500 Operation Guide Rev-1.3 - Page 65
Others, >Sleep timer, >>Sleep Mode, >Print HEX-DUMP, Processing, Waiting, ENTER
UPC - 632983001073
View all Kyocera FS-9500DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 3 Using the Operator Panel 6 Press the 3 or 4 key to increase or decrease the value of the figure where the cursor is blinking and set the desired time. The timer can be set between 5 and 240 min, in 5-minute increments. You can use the 2 and 1 keys to move the cursor right and left. 7 Press the ENTER key. 8 Press the MENU key. The message display returns to Ready. Q Turning Off the Sleep Timer You can turn off the sleep timer function by following the procedure given below. 1 Press the MENU key. 2 Press the 3 or 4 key repeatedly until Others > appears. Others > 3 Press the 2 key. 4 Press the 3 or 4 key repeatedly until >Sleep Timer >appears. >Sleep timer > 030 min. 5 Press the 2 key and display >>Sleep Mode. >>Sleep Mode On 6 Press the ENTER key. A blinking question mark (?) appears. >>Sleep Mode ? On 7 Select Off using the 3 or 4 key. >>Sleep Mode ? Off 8 Press the ENTER key. 9 Press the MENU key. The message display returns to Ready. 3-49 Received Data Dumping It is possible to print data received by the printer as hexadecimal code for the purposes of debugging programs and files. 1 Press the MENU key. 2 Press the 3 or 4 key repeatedly until Others > appears. Others > 3 Press the 2 key. 4 Press the 3 or 4 key repeatedly until >Print HEX- DUMP appears. >Print HEX-DUMP 5 Press the ENTER key. A question mark (?) appears. >Print HEX-DUMP? 6 Press the ENTER key again. Processing appears for a second, and then Waiting appears. Processing Waiting 7 Send data to be dumped to the printer. The message Processing will be displayed while receiving the data. Once the dumped data you require has been printed, it is possible to cancel the printing of any further dumped data by taking the printer offline by pressing the GO key and then pressing the CANCEL key. 8 Once all data has been received, the message Waiting will appear. Press the GO key to finish printing. Printer Resetting The procedure described below resets the printer's temporary conditions, such as the current unit of measurement, page orientation, font, character code set, margins, etc., set by commands to their default values.