Kyocera FS3820N FS-3820N/3830N Operation Guide Rev-1.1 - Page 155
Maintenance Messages, Table 4-4 - mita fs
View all Kyocera FS3820N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Indicators and Messages Maintenance Messages The following table lists maintenance messages that you can deal with by yourself. If Call service person appears, turn off the printer, disconnect the power cord, and contact your Kyocera Mita dealer. Message Corrective Action Add paper (paper source) The paper has run out. Supply paper according to the paper source displayed (paper cassette, MP tray, or option paper feeder). Messages indicating the printer status (Ready, Please wait, Processing†, Waiting, and FormFeed Time Out†) are displayed alternately. Call service F000 The ATTENTION indicator turns on and the READY indicator goes off. Indicates a problem with the controller and the operator panel. Call a service person. The printer does not operate when this message is displayed. Call service #### The ATTENTION indicator turns on. Indicates a controller error. Call a service person. The printer does not operate when this message is displayed. Call service ####:0123456 The ATTENTION indicator turns on. Indicates a mechanical error. Or an unsupported option hardware has been installed. Be sure to install proper option hardware compatible with the FS-3830N. Call a service person. 0123456 indicates the number of printed pages. Cassette # not loaded The paper cassette may not be properly inserted into the printer. Reinsert the paper cassette. The paper source number (#) is only displayed when there is an option paper feeder installed. Check waste toner box The waste toner box is not installed. After installing the waste toner box, you should be able to print. Replace the old waste toner box with the new one which is included in the toner kit. The message will also be shown if the waste toner box has become full. The waste toner box should be replaced when the message display eventually shows ;ÒToner low. See Toner Container Replacement on page 3-2. Clean printer Press GO Please clean the inside of the printer. See Cleaning on page 3-9. This message will be displayed when replacing the toner container after the message Replace toner Clean printer is displayed. After cleaning the inside of the printer, press the GO key and the printer will be ready for printing. If Auto Continue is set to On, printing will be automatically resumed after a preset ;Òperiod of time. Close duplexer rear cover Open the option duplexer rear cover, then close tightly. Close left cover Open the left cover, then close tightly. Close sorter rear cover Open the sorter rear cover, then close tightly. Close top cover Open the top cover, then close tightly. Close paper transfer unit Open the paper transfer unit, then close tightly. Duplex disabled You attempted to print with a paper size and paper type that cannot be used for Press GO duplex printing. Press the GO key to print onto one-side of the paper only. ;Ò:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer. Table 4-4 4-7