Kyocera KM-3060 PRESCRIBE Commands Technical Reference Manual - Rev. 4.7 - Page 12
Format of PRESCRIBE Commands, Basic Concepts, Edge Limits, Margins
View all Kyocera KM-3060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Chapter 1 Introduction to PRESCRIBE Format of PRESCRIBE Commands The basic format of a PRESCRIBE command is or command name) parameter, ..., parameter; The command names generally consist of three or four letters. In most commands, the parameters must be followed by commas. The last parameter is always followed by a semicolon. Some commands (RES, for example) have no parameters. In this case, the command should be followed immediately by a semicolon (RES;). The length of a single PRESCRIBE command is limited to 255 characters, from the first letter of the command name through the final semicolon. Commands longer than 255 characters are not executed. Spaces, carriage return codes, and line feed codes are generally ignored in PRESCRIBE command sequences. These characters are not generally counted in the command length. (Exception: Spaces are not ignored in quoted character strings.) To improve readability, place at least one space before each command or place each command on a separate line. Basic Concepts This section discusses a few basic concepts concerning how the printing system prints on the page. These concepts are: • Edge limits • Margins • Coordinate systems • Text positioning/Character spacing • Paths • Logical page and physical page • Page orientation and direction Edge Limits The printing system cannot place print on the outside edges of the paper. The edge limits to which printing is possible are located 5 mm inside the edges of the paper; or 6 mm (5mm in landscape orientation) from the left edge and 4 mm from the top of the paper in HP LaserJet emulation. Refer to the figure Edge Limits and Margins on page 5. The edge limits adjust automatically to the size of the paper cassette (although not to the size of manually fed paper). The edge limits can also be set to various standard sizes by the SPSZ (set paper size) command, or by the equivalent HP LaserJet commands. In HP LaserJet emulation, the edge limits slightly vary according to the page orientation (as also shown in Edge Limits and Margins on page 5). Margins The top and left margins are set in centimeters or inches in relation to the top and left edge limits of the page. The bottom and right margins can also be set as a distance from the top and left edge limits, or they can be set in terms of page width, page length, or lines per page. 1-4