Kyocera KM-4030 Printing System N Operation Guide (Functions Edition) - Page 14
Interface Settings, Available settings, Remarks
View all Kyocera KM-4030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
4. Selecting the Printer Settings 4-2 Interface Settings About the interface settings It is possible to perform interface settings for the 17 items shown in the following chart. For the most efficient use of the printer functions, select the various settings according to your printing needs. Item Available settings 1 Interface selection Parallel, Serial, Network Sets the interface that will be used for printing. The currently selected interface will be highlighted. The printer will automatically switch to the appropriate interface for printing. 2 Parallel TX/RX mode Sets the transmission and reception mode when the printer is connected to your computer with a parallel interface. Auto, Normal, High Speed, Nibble (high) 3 Baud rate 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 4 Data bit length 7, 8 5 Stop bit length 1, 2 6 Parity None, Odd, Even, Ignore 7 Protocol DTR(positive)&XON/XOFF, DTR (positive), DTR (negative), XON/XOFF, ETX/ACK 8 Barcode mode ON/OFF OFF, ON 9 NetWare ON/OFF OFF, ON 0 NetWare Frame Type Sets the NetWare Frame type. Auto, 802.3, Ethernet 2, 802.2, 802.3 SNAP ! TCP/IP ON/OFF OFF, ON @ DHCP ON/OFF OFF, ON # IP address Enter the appropriate network address. $ Subnet Mask Enter the appropriate network address. % Gateway address Enter the appropriate network address. ^ Ether Talk ON/OFF OFF, ON & Network Card Status Page print out OFF, ON Prints out a Status page for the Network Card as well, when the standard Status Page (page 4-1) or that for use by your service representative (page 4-47) are printed out. A more detailed Status Page will be printed out together with the Service Representative Status Page print out. Remarks Displayed only when the Barcode Reader is installed. Displayed only when the NetWare setting is turned "ON". 4-2