Kyocera KM-5050 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 328
SPD
View all Kyocera KM-5050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 328 highlights
PRESCRIBE Command Reference SPD - Set Pen Diameter Format SPD diameter; Parameter diameter: line thickness Function The SPD command sets the thickness of the line used in the graphics commands (DRP, PDRP, etc.). The thickness is specified in the unit value designated by the UNIT command. The maximum thickness is 4200 dots (14 inches or 35.56 centimeters) in path graphics mode, and 127 dots (0.42 inches or 1.08 centimeters) in standard graphics mode. The minimum thickness is 1 dot (about 0.01 centimeters or 0.0033 inches). The printing system rounds off all decimal values to the nearest integer value. The SPD command affects graphics segments created by DZP, DAP, DRP, DRPA, BOX, CIR, and PIE commands. It also affects the width of the line and curve segments stroked as paths. A slant line drawn by the standard graphics commands becomes thicker than specified by the SPD command. The effect may be most noticeable with a 45° slant. In the path mode graphics, however, the thickness of any slant lines is automatically adjusted so that the slant lines are maintained in constant thickness as specified by SPD. (See below.) Thickness of the line drawn by printing system Thickness specified by SPD 318