Kyocera KM-C2520 C2520/C3225/C3232 Operation Guide (Basic Edition) - Page 142
Printer Error Messages, Printer, Error Messages, Checkpoints, Corrective Actions, Reference
View all Kyocera KM-C2520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Troubleshooting Error Messages Please wait. Remote edit. Security key is not recognized. Not available. Checkpoints Corrective Actions Reference Page Is Job account editing being done Copying is not possible until editing - from a network connected is complete. computer? Is it re-displayed after opening and Contact your Service Representative - closing the front cover, turning off or Authorized Service Center. and on the main power switch, and plugging out and plugging in the power plug in the power outlet? Printer Error Messages If the Printer mode touch panel displays any of these messages after pressing the Printer key, follow the corresponding procedure. Error Messages Checkpoints Corrective Actions Reference Page Load Paper. ## size (##) Does the print data match the feed Replace the size or type of source page 2-2 paper size and paper type? paper. To change the paper source, select paper source from the touch panel and press [GO]. To print on the loaded paper, press the Printer key and press [GO]. To cancel printing, press the Printer key and press [Cancel]. Use alternative? Press GO. - Displayed when paper source is - changed. Press [GO]. Set paper Press GO. - This mode supplies paper one sheet - at a time even if multiple sheets have been loaded. To feed each sheet, press [GO]. Load Paper. Is the paper source empty? Load more paper. page 2-2 Out of staples. Add staples. (Stapler empty. Add staples.) Is the optional document finisher or Refer to the optional document - 3000 sheet document finisher out of finisher or 3000 sheet document staples? finisher Operation Guide to refill staples. Call service. - An internal error has occurred. - Contact your Service Representative or Authorized Service Center. Account ID mismatch. - No matching ID-code found. Verify - the registered ID-code using the driver. Error has occur. PLS change to printer screen and check. - Shown when a printer error has - occurred when other modes are currently being displayed. Press the Printer key to switch to the printer screen and display the specific error message. Option interface error Code: ## Is the installed option interface slot Switch the main power switch to off - incorrect? ( position) and install in the correct slot. 6-8