Kyocera TASKalfa 3051ci PRESCRIBE Commands Technical Reference Manual - Rev. 4 - Page 104
Table 6.1., Interface-dependent Parameters Sheet 3 of 3, Permanent Parameters
View all Kyocera TASKalfa 3051ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Chapter 6 Permanent Parameters Table 6.1. Interface-dependent Parameters (Sheet 3 of 3) Environment Parameter Value Factory setting Character spacinga U2 Characters per inch (integer value) 10 Character spacinga U3 Characters per inch (fraction value) 0 Country code U6 0: US-ASCII 0 1: France 2: Germany 3: UK 4: Denmark 5: Sweden 6: Italy 7: Spain 8: Japan 9: US Legal 10: IBM PC-850 (Multilingual) 11: IBM PC-860 (Portuguese) 12: IBM PC-863 (Canadian French) 13: IBM PC-865 (Norwegian) 14: Norway 15: Denmark 2 16: Spain 2 17: Latin America 50 - 99:HP PCL symbol set coding (See page 737.) Code set at power up in U7 daisywheel emulation 0: Same as the default emulation mode (P1) 0 1: IBM 2: Daisywheel 3: HP Roman8 (US ASCII) 4: Same as 3 5: Epson LQ-850 6: HP Roman-8 7 - 99:HP PCL symbol set coding (See page 737.) Font pitch for fixed- U8 Integer value in cpi: 0 - 99 10 pitch scalable fonts U9 Fraction value in 1/100 cpi: 0 - 99 0 Font height for the V0 Integer value in 100 points: 0-9 0 default scalable fonta V1 Integer value in points: 0-99 12 V2 Default scalable fonta, e V3 Fraction value in 1/100 points: 0, 25, 50, or 75 0 Name of typeface of up to 32 characters, enclosed - with single or double quotation marks a Ignored in some emulation modes. b For models supporting A3 and ledger size paper. c Characters higher than 127 are printed regardless of the C8 value. However, setting C8 to 0 does not print character code 160. d P4/P5-Automatic Emulation Switching The FRPO P4 command establishes Automatic Emulation Switching (AES) between KPDL and the alternative emulation. With the P4 value of 1, the printing system will switch from KPDL emulation to non-KPDL emulation, or vice versa. Switching is triggered by the command specified by the FRPO P7 value. The FRPO P5 value specifies the alternative emulation to which the printing system switches from KPDL. The factory default for P5 is the HP LaserJet. The automatic emulation switching mode may not operate properly if the print job contains PRESCRIBE commands. 6-4