LG 50PX1D Owners Manual - Page 50
Extemal, Control, Device, Setup - h 50 in plasma tv
View all LG 50PX1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
ExtemCaol ntrDolevicSeetup * All data are transmitted by Hexadecimal code *Two/One part Channel: 6th bit This bit is used in a cable-ready system. *Using physical channel: 5th bit If the channel band is NTSC air or NTSC cable, channel tuning can be done by only physical channel. In this case, using physical channel bit must be low(0). But if the channel band is ATSC air or ATSC cable, there are two cases that physical channel enable or disable. If the physical channel sending is meaningful, you should set this bit low(0). If the physical channel sending is meaningless, you should set this bit high(1 ). Example) 1. Analog channel: NTSC cable, channel number(35), main picture Command: ma 00 23 xx xx xx xx 01 attribute(0x01 ): main picture, two part(it's not mandatory), using physical channel, NTSC cable 'xx' data: don't care major and minor channel number in case analog channel tuning. 2. Digital channel: ATSC air, channel number(don't know physical channel, major(30), minor(3)), sub picture Command: ma 00 xx 00 1E 00 03 A2 attribute(0xA2): sub picture, two part, not using physical channel, ATSC air 'xx' data: don't care analog channel number in case digital channel tuning. 3. Digital channel: ATSC air, channel number(physical(20),major(20), minor(3)), sub picture Command: ma 00 14 00 14 00 03 82 attribute(0x82): sub picture, two part, using physical channel, ATSC air. 25. Input select(Command: x b) (Main Picture Input) G To select input source for TV. Transmission I[x][b][][Set ID][][Data][Cr] ] Data Structure DATA(Hex) oo 01 10 11 20 21 40 41 50 INPUT DTV (Antenna) DTV (Cable) Analog (Antenna) Analog (Cable) Video Front Video Component 1 Component 2 RGB DTV Acknowledgement [a][ ][Set ID][ ][OK][Data0][Datal ][Data2][Data3][Data4][Data5][x] I [a][ ][Set ID][ ][NG][Data0][x] 60 RGB PC 90 HDMI/DVl 23. Channel Add/Del (Command: G To add and delete the channels Transmission m b) l[m][b][ ][Set ID][ ][Data][Cr] I Data 0: Channel Delete 1: Channel Add Acknowledgement I[b][ ][Set ID][ ][OK][Data][x] [b][ ][Set I D][ ][NG][Data][x] Acknowledgement [[b][ ][Set ID][ ][OK/NG][Uata][x] 24. Key (Command: m c) G To send IR remote key code Transmission [[m][c][ ][Set ID][ ][Data][ ][Cr] ] Data Key code: Refer to page 52. Acknowledgement I[c][ ][Set IU][ ][OK][Uata][x] ] 50 Plasma TV