LG 55EJ5E User Guide - Page 68
Remote Controller Key Lock Command: t p, Local Key Lock] Command: t o, Check [Status] Command: s v
View all LG 55EJ5E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
ENGLISH 68 44. Remote Controller Key Lock (Command: t p) Configures the settings of the product's remote control key. Transmission (t)(p)( )([Set ID])( )(Data)(Cr) Data 00: All keys lock off 01: Locks on all keys except Power key 02: Locks on all keys Acknowledgment (p)( )([Set ID])( )(OK/NG)(Data)(x) * When the monitor is turned off, the power key works even in the locks on all of the keys (02) mode. 45. [Local Key Lock] (Command: t o) Configures the local key operation settings of the product. Transmission (t)(o)( )([Set ID])( )(Data)(Cr) Data 00: All keys lock off 01: Locks on all keys except Power key 02: Locks on all keys Acknowledgment (o)( )([Set ID])( )(OK/NG)(Data)(x) * When the monitor is turned off, the power key works even in the locks on all of the keys (02) mode. * This feature may not be supported on some models. 46. Check [Status] (Command: s v) Checks the current signal of the product. Transmission (s)(v)( )([Set ID])( )(Data)( )(FF)(Cr) Data 02: Checks whether there is a signal 03: The monitor is currently in [PM Mode] 07: Checks whether the Top, Bottom and Main temperature sensors are functioning normally. 08: The temperature of each temperature sensor when the monitor set was last powered off. 09: Fan speed 10: RGB Sensing OK/NG (screen fault detection) Acknowledgment (v)( )([Set ID])( )(OK/NG)(Data)(Data1)(x) Data 02 (when a signal is found) Data1 00: No signal 01: Signal present Data 03 (when the monitor is currently in PM mode) Data1 00: [Screen On] is activated. 01: [Screen Off] is activated. 02: [Screen Off Always] is activated. 03: [Sustain Aspect Ratio] is activated. 04: [Screen Off & Backlight] is activated. Data 07 (when checking whether the Top, Bottom and Main temperature sensors are working properly) Data1 00: All temperature sensors faulty 01: Top normal, Bottom faulty, Main faulty 02: Top faulty, Bottom normal, Main faulty 03: Top normal, Bottom normal, Main faulty 04: Top faulty, Bottom faulty, Main normal 05: Top normal, Bottom faulty, Main normal 06: Top faulty, Bottom normal, Main normal 07: All temperature sensors are normal Data 10 (when executing [Screen Fault Detection]) Data1 00: [Screen Fault Detection] result NG 07: [Screen Fault Detection] result OK * When screen Fault Detection is set to Off or not supported, execution results are rendered "NG."