LG 60LB6500 Owners Manual - Page 31

ENEGNLGISH MAGIC REMOTE FUNCTIONS 31 MAGIC REMOTE FUNCTIONS When the message Magic remote control battery is low. Change the battery . is displayed, replace the battery. To install batteries, open the battery cover, replace batteries (1.5 V AA) matching and ends to the label inside the compartment, and close the battery cover. Failure to match the correct polarities of the battery may cause the battery to burst or leak, resulting in fire, personal injury, or ambient pollution. Be sure to point the remote control at the remote control sensor on the TV. To remove the batteries, perform the installation actions in reverse. CAUTION y Do not mix old and new batteries, as this may damage the remote control. This remote uses infrared light. When in use, it should be pointed in the direction of the TV's remote sensor. Wheel (OK) Press the center of the Wheel button to select a menu. You can change channels and scroll the menu by using the Wheel button. (BACK) Returns to the previous screen. (EXIT to LIVE) Switches among broadcast (antenna) and various inputs. Color buttons These access special functions in some menus. ( : Red, : Green, : Yellow, : Blue) VOL Adjusts the volume level. /INPUT Displays the Screen Remote. * Accesses the Universal Control Menu in some regions. * Pressing and holding the button will display a menu to select an external device that is connected to the TV. Used for viewing 3D video. (MUTE) Mutes all sounds. * By pressing and holding the button, VD function will be enabled. SAP(Secondary Audio Program) Feature can also be enabled by pressing the key. . CH Scrolls through the saved channels. /INPUT VOL CH (POWER) Turns the TV on or off. Navigation buttons (up/down/left/right) Press the up, down, left or right button to scroll the menu. If you press buttons while the pointer is in use, the pointer will disappear from the screen and Magic Remote will operate like a general remote control. To display the pointer on the screen again, shake Magic Remote to the left and right. (Smarthome) Accesses the Smarthome menu. (Voice recognition) Network connection is required to use the voice recognition function. 1. Press the voice recognition button. 2. Speak when the voice display window appears on the left of the TV screen. * Use the Magic Remote no further than 10 cm (4 inch) from your face. * The voice recognition may fail when you speak too fast or too slowly. * The recognition rate may vary depending upon the user's characteristics (voice, pronunciation, intonation, and speed) and the environment (noise and TV volume). P