LG BX403B Owners Manual - Page 32

RS-232C Serial * Connect the RS-232C input jack to an external control device (such as a computer) and control the Projector's functions externally. SET ID 1. Press the MENU button and then use ＜,＞ button to select the menu. Keystone Blank Image 2. Press the ◉ OK button and then use ∧,∨ button to select Set ID item. Captured Image Lamp mode 3. Press the ＜,＞ button to select your desired number. Press the ◉OK button to save the selected number. Monitor Out Communication • The adjustment range of Set ID is 1~99. • Only the projector with the specified ID number will operate from the remote control. • Press the MENU button twice or the EXIT button to exit the menu screen. Set ID Network Setting Lamp Time ꘀ Prev. ＜ Black ＞ ＜ High bright ＞ ＜ RGB1 ＞ ＜ Serial ＞ ＜ 1 ＞ ＜ Auto ＞ 0 Hr ꕌ ꕍ Move ◉ OK Serial • Connect the serial port of the PC to the RS-232C jack on the projector back panel. • RS-232C cable is not supplied with the projector. • Use the RS232C cable to control the projector externally (Refer to Fig.1). RXD 2 TXD 3 DTR 4 GND 5 DSR 6 RTS 7 CTS 8 PC 2 RXD 3 TXD 4 DTR 5 GND 6 DSR 7 RTS 8 CTS Projector 96 5 1 * 1, 9 Pin No Connection Communication Parameter Setup • Baud Rate : 9600 bps(UART) • Data Length : 8 bit • Parity : none • Stop bit : 1 bit • Flow Control : none • Communication code : ASCII code 32