LG BX503B Owners Manual - Page 42

Information Regarding the projector lamp control WARNING l Don't turn off the projector at least in 5 minutes after activating it. - The frequent On/Off changes may cause the lamp function to deteriorate. l Don't pull out the power cord while activating the projector and the cooling fan. - It may cause the lamp life-span to shorten and get damaged. l The life-span of projector may considerably depend on the use environment and treatment conditions. l The projector uses the high pressure mercury lamp so that the serious caution is essential. The shock or abuse while using may cause lamp to blow off with explosion. l When you continue to use the projector after an interval of lamp replacement, the lamp may be blown off with explosion. l The following treatment should be done, in case of lamp blow-off. - Pull off the power cord immediately. - Let some fresh air in immediately (Ventilation). - Check the product condition at the nearer service center and replace it with new lamp, if necessary. - Don't try to disassemble the product without the authorized technician. How to fix the lens cap to the projector How to fix the lens cap 1 Prepare the lens cap and the strap supplied as accessories. 2 Insert the non-knot end of the strap into the hole at the bottom of the lens section of the projector. Fix the strap at the hole of the projector into the 3 hole of the lens cap, and then pass the lens cap through the strap lasso. 4 They are completely assembled as shown at the below figure. 42