LG DLE4970W Owners Manual - Page 27

Installation Test Duct check

Get LG DLE4970W PDF manuals and user guides View all LG DLE4970W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

ENGLISH INSTALLATION INSTRUCTIONS 27 Installation Test (Duct check) Once you have completed the installation of the dryer, use this test to make sure the condition of the exhaust system is adequate for proper operation of the dryer. This test should be performed to alert you to any serious problems in the exhaust system of your home. t:PVSESZFSGFBUVSFT'MPX4FOTF™, an innovative sensing system that automatically detects blockages and SFTUSJDUJPOTJOESZFSEVDUXPSL,FFQJOHEVDUXPSLDMFBO of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use. NOTE The dryer should be cool before starting this test. If the dryer was warmed up during installation, run the AIR DRY cycle for a few minutes to reduce the interior temperature. 5PBDUJWBUFUIFJOTUBMMBUJPOUFTU 3FNPWFUIFMJUFSBUVSF BOEUIFODMPTFUIFEPPS Do not load anything in the drum for this test, as in may affect the accuracy of the results. $ IFDLUIFEJTQMBZGPSSFTVMUT During the three minute test cycle, monitor the Flow Sense™ display on the control panel. If no bars are displayed, when the cycle ends, the exhaust system is adequate. If the exhaust system is severely restricted, the display will show four bars. Other problems may also be shown with error codes. Refer to the next page for error code details and solutions. /P#BST0L 'PVS#BST Restricted Four bars indicates that the exhaust system is severely restricted. Have the system checked immediately, as performance will be poor. &OEPGDZDMF At the end of the test cycle, will display. The test cycle will end and the dryer will shut off automatically after a short delay. 1SFTTBOEIPMEUIF5FNQ$POUSPMBOE4JHOBM CVUUPOTBOEUIFOQSFTTUIF1PXFSCVUUPO This button sequence activates the installation test. The code will display if the activation is successful. 1SFTT4UBSU1BVTFCVUUPO The dryer will start the test, which will last about two minutes. The heat will be turned on and the temperatures in the drum will be measured.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
27
ENGLISH
Installation Test (Duct check)
Once you have completed the installation of the dryer,
use this test to make sure the condition of the exhaust
system is adequate for proper operation of the dryer.
This test should be performed to alert you to any serious
problems in the exhaust system of your home.
™, an innovative sensing
system that automatically detects blockages and
of lint buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
Do not load anything in the drum for this test, as in
may affect the accuracy of the results.
This button sequence activates the installation test.
The code
will display if the activation is
successful.
The dryer will start the test, which will last about
two minutes. The heat will be turned on and the
temperatures in the drum will be measured.
During the three minute test cycle, monitor the
Flow Sense™ display on the control panel. If no bars
are displayed, when the cycle ends, the exhaust
system is adequate. If the exhaust system is severely
restricted, the display will show four bars. Other
problems may also be shown with error codes. Refer
to the next page for error code details and solutions.
Four bars indicates that the exhaust system is severely
restricted. Have the system checked immediately, as
performance will be poor.
At the end of the test cycle,
will display.
The test cycle will end and the dryer will shut off
automatically after a short delay.
Restricted
NOTE
The dryer should be cool before starting this test. If
the dryer was warmed up during installation, run the
AIR DRY cycle for a few minutes to reduce the interior
temperature.
INSTALLATION INSTRUCTIONS