LG DLEX3550W Owner's Manual - Page 42

42 SPECIFICATIONS Before calling for service (cont.) Problem Steam does not generate but no error code is shown Possible Causes • Water level error. Solutions • Unplug dryer and call for service. Garments still wrinkled after Steam Fresh™ • Too many or too different types of garments • Small loads of 1 to 5 items work best. in dryer. • Load fewer garments. Load similar-type garments. There are no creases left on garment after Steam Fresh™ •The function of this cycle is to remove wrinkles from fabric. • Use an iron to make creases. Garments have static after REDUCE STATIC • This is normal. • Depends on individual moisture level in skin. Garments are too damp or too dry after REDUCE STATIC • Correct drying options not selected. • Select load weight manually before starting REDUCE STATIC option. Garments are not uniformly • N umber of garments or load size not properly • Select the correct number or garments or load size before starting the cycle. damp after EASY IRON selected at the beginning of the cycle. Water drips from door • This is normal. during Steam Cycle • Condensation will normally form on the inside of the dryer door during steam operation. Some condensation may drip out the bottom of the door. Steam is not visible during Steam Cycle • This is normal. • Steam vapor is difficult to see when the door is closed. However, condensation will normally form on the inside of the dryer door if the steam system is operating normally. Drum does not turn during Steam Cycle • This is normal. • The drum is turned off so that the steam vapor remains in the drum. The drum will normally turn for about 2 seconds once a minute. Cannot see steam vapor at the beginning of cycle • This is normal. • Steam is released at different stages of the cycle for each option. The display shows • MORE TIME button pressed. • This display indicates that the steam option has been set for a " as a comforter. Press the LESS TIME button to reduce the indicated load size. " item such Odors remain in clothing after STEAM FRESH™ • STEAM FRESH™ did not remove odor completely. • Fabrics containing strong odors should be washed in a normal cycle. CHECK FILTER light is on during the drying cycle FLOW SENSETM indicator shows four bars during the drying cycle • Lint filter is almost clogged or full. • Pause the drying cycle and clean the lint filter. • Ductwork is too long or has too many turns/ restrictions. • Significant blockage of the ductwork due to lint buildup or debris. • The appliance has detected a restriction in the external dryer venting. • Install a shorter or straighter duct run. See the Installation Instructions. • Ductwork should be checked/cleaned soon. Dryer can be used in this condition, but drying times may be longer. • If exhaust restrictions are sensed by the FLOW SENSETM system, the indicator will remain on for two hours after the end of the cycle. Opening the door or pressing the POWER button will turn off the display. SPECIFICATIONS Steam Dryer™ Models Description Electrical Requirements* Gas Requirements* Dimensions Net Weight Drying Capacity - Normal Cycle - Steam Cycle DLEX3550* DLGX3551* Steam Dryer Please refer to the rating label regarding detailed information. NG 4-10.5 inches WC LP: 8-13 inches WC (Gas Models only) 27" (W) X 30" (D) X 3811/16" (H), 51" (D with door open) 68.6 cm (W) X 76.1 cm (D) X 98.3 cm (H), 129.7 cm (D with door open) 136 lbs (62 kg) IEC 7.4 cu.ft. (22.5 lb/10.2 kg) IEC 7.4 cu.ft. (8 lb/3.6 kg)