LG DLGX2551R Owner's Manual - Page 41

ENGLISH BEFORE CALLING FOR SERVICE (cont.) Problem Steam doesn't generate but no error code is shown Garments still wrinkled after Steam Fresh™ There are no creases left on garment after Steam Fresh™ Garments have static after REDUCE STATIC Garments are too damp or too dry after REDUCE STATIC Garments are not uniformly damp after EASY IRON Water drips from door during Steam Cycle Possible Causes • Water level error. • Too many or too different types of garments in dryer. • The function of this cycle is to remove wrinkles from fabric. • This is normal. • Correct drying options not selected. • Number of garments or load size not properly selected at the beginning of the cycle. • This is normal. Steam is not visible during Steam Cycle • This is normal. Drum does not turn during Steam Cycle • This is normal. Cannot see steam vapor at the beginning of cycle The display shows • This is normal. • MORE TIME button pressed. Odors remain in clothing after STEAM FRESH™ CHECK FILTER light is on during the drying cycle FLOW SENSE indicator light is on during the drying cycle • STEAM FRESH™ did not remove odor completely. • Lint filter is almost clogged or full. • Ductwork is too long or has too many turns/restrictions. • Significant blockage of the ductwork due to lint buildup or debris. • The appliance has detected a restriction in the external dryer venting. Solutions • Unplug dryer and call for service. • Small loads of 1 to 5 items work best. • Load fewer garments. Load similar-type garments. • Use an iron to make creases. • Depends on individual moisture level in skin. • Select load weight manually before starting REDUCE STATIC option. • Select the correct number or garments or load size before starting the cycle. • Condensation will normally form on the inside of the dryer door during steam operation. Some condensation may drip out the bottom of the door. • Steam vapor is difficult to see when the door is closed. However, condensation will normally form on the inside of the dryer door if the steam system is operating normally. • The drum is turned off so that the steam vapor remains in the drum. The drum will normally turn for about 2 seconds once a minute. • Steam is released at different stages of the cycle for each option. • This display indicates that the steam option has been set for a " " item such as a comforter. Press the LESS TIME button to reduce the indicated load size. • Fabrics containing strong odors should be washed in a normal cycle. • Pause the drying cycle and clean the lint filter. • Install a shorter or straighter duct run. See the Installation Instructions. • Ductwork should be checked/cleaned soon. Dryer can be used in this condition, but drying times may be longer. • If exhaust restrictions are sensed by the FLOW SENSE system, the indicator will remain on for two hours after the end of the cycle. Opening the door or pressing the POWER button will turn off the display. 41