LG DLGX3251W Owners Manual - Page 27
Three-wire connection for electric dryers: Direct wire
View all LG DLGX3251W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
ENGLISH INSTALLATION INSTRUCTIONS 27 Connecting electric dryers (cont.) USA only wWarning • Connect the power cord to the terminal block. Connect each power cord wire to the terminal block screw that has the same colored wire. For example, connect the black power cord wire to the terminal block screw with the black wire. Failure to follow these instructions may result in a short, overload, fire or death. • Grounding through the neutral conductor is prohibited for: (1) new branch-circuit installations, (2) mobile homes, (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductor. Three-wire connection for electric dryers: Direct wire • A 3-wire connection is NOT permitted on new construction after January 1, 1996. • A UL-listed strain relief is required. 1. Remove 31⁄₂ inches (8.9 cm) of the outer covering from the wire. Strip 1 inch (2.5 cm) insulation from each wire. Bend the ends of the three wires into a hook shape. 1" (2.5 cm) • U se UL-listed 3-wire #10 AWG-minimum copper conductor cable. • A llow at least 5 ft. (1.5 m) length to allow for removal and reinstallation of the dryer. 3. A ttach the two hot leads of the power cord to the outer terminal block screws. Attach the neutral wire to the center terminal block screw. Connect the external ground (if required by local codes) to the green ground screw. Tighten all screws securely. Reinstall the terminal block access cover. Ground Screw Hot (Black) Neutral (White) Hot (Red) White Wire from Dryer harness External Ground Wire (If required by local codes) 2. Remove the terminal block access cover on the upper back of the dryer. Install a UL-listed strain relief into the power cord through-hole; then thread the power cable prepared in Step 1 through the strain relief. Terminal Block UL-Listed Strain Relief UL-Listed 3-Wire Power Cord