LG DLGX3571W Owners Manual - Page 29
Installation test Duct
View all LG DLGX3571W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
ENGLISH INSTALLATION INSTRUCTIONS 29 Installation test (Duct) Once you have completed the installation of the dryer, use this test to make sure the condition of the exhaust system is adequate for proper operation of the dryer. This test should be performed to alert you to any serious problems in the exhaust system of your home. t:PVSESZFSGFBUVSFTFLOW SENSETM, an innovative sensing system that automatically detects blockages BOESFTUSJDUJPOTJOESZFSEVDUXPSL,FFQJOHEVDUXPSL clean of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use. NOTE The dryer should be cool before starting this test. If the dryer was warmed up during installation, run the AIR DRY cycle for a few minutes to reduce the interior temperature. 5PBDUJWBUFUIF*OTUBMMBUJPOUFTU 3FNPWFUIFESZJOHSBDLBOEMJUFSBUVSF BOEUIFO DMPTFUIFEPPS Do not load anything in the drum for this test, as in may affect the accuracy of the results. 4. $IFDLUIFEJTQMBZGPSSFTVMUT During the two minute test cycle, monitor the FLOW SENSETM display on the control panel. If no bars are displayed, when the cycle ends, the exhaust system is adequate. If the exhaust system is severely restricted, the display will show four bars. Other problems may also be shown with error codes. Refer to the next page for error code details and solutions. /0#"34 0, '063#"34 RESTRICTED Four bars indicates that the exhaust system is severely restricted. Have the system checked immediately, as performance will be poor. &OEPGDZDMF At the end of the test cycle, will display. The test cycle will end and the dryer will shut off automatically after a short delay. 1SFTTBOEIPMEUIF4*(/"-0/0''BOE5&.1 $0/530-CVUUPOTBOEUIFOQSFTTUIF108&3 CVUUPOThis button sequence activates the installation test. The code will display if the activation is successful. 3. 1SFTT45"351"64&CVUUPO The dryer will start the test, which will last about two minutes. The heat will be turned on and the temperatures in the drum will be measured.