LG DLGX8501V Owners Manual - Page 46
Specifications
View all LG DLGX8501V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
46 SPECIFICATIONS Before calling for service (cont.) Problem Steam does not generate but no error code is shown Garments still wrinkled after Steam Fresh™ There are no creases left on garment after Steam Fresh™ Garments have static after Reduce Static Garments are too damp or too dry after Reduce Static Garments are not uniformly damp after Easy Iron Water drips from door during Steam Cycle Steam is not visible during Steam Cycle Drum does not turn during Steam Cycle Cannot see steam vapor at the beginning of cycle The display shows Load Bulky items Odors remain in clothing after Steam Fresh™ CHECK FILTER light is on during the drying cycle Flow SenseTM indicator shows four bars during the drying cycle Possible Causes • Water level error. Solutions • Unplug dryer and call for service. • Too many or too different types of garments • Small loads of 1 to 5 items work best. in dryer. • Load fewer garments. Load similar-type garments. •The function of this cycle is to remove wrinkles from fabric. • Use an iron to make creases. • This is normal. • Depends on individual moisture level in skin. • Correct drying options not selected. • Select load weight manually before starting Reduce Static option. • N umber of garments or load size not properly • Select the correct number or garments or load size before starting the cycle. selected at the beginning of the cycle. • This is normal. • This is normal. • This is normal. • This is normal. • Condensation will normally form on the inside of the dryer door during steam operation. Some condensation may drip out the bottom of the door. • Steam vapor is difficult to see when the door is closed. However, condensation will normally form on the inside of the dryer door if the steam system is operating normally. • The drum is turned off so that the steam vapor remains in the drum. The drum will normally turn for about 2 seconds once a minute. • Steam is released at different stages of the cycle for each option. • More Time button pressed. • Steam Fresh™ did not remove odor completely. • Lint filter is almost clogged or full. • This display indicates that the steam option has been set for a "Load Bulky items" item such as a comforter. Press the LESS TIME button to reduce the indicated load size. • Fabrics containing strong odors should be washed in a normal cycle. • Pause the drying cycle and clean the lint filter. • Ductwork is too long or has too many turns/ restrictions. • Significant blockage of the ductwork due to lint buildup or debris. • The appliance has detected a restriction in the external dryer venting. • Install a shorter or straighter duct run. See the Installation Instructions. • D uctwork should be checked/cleaned soon. Dryer can be used in this condition, but drying times may be longer. • If exhaust restrictions are sensed by the FLOW SENSETM system, the indicator will remain on for two hours after the end of the cycle. Opening the door or pressing the POWER button will turn off the display. SPECIFICATIONS Steam Dryer™ Models Description Electrical Requirements* Gas Requirements* Dimensions Net Weight Drying Capacity - Steam Cycle DLEX8500* DLGX8501* Steam Dryer Please refer to the rating label regarding detailed information. NG: 4-10.5 inches WC LP: 8-13 inches WC (Gas Models only) 29"(W) x 32.1"(D) x 40.8''(H) x 59"(D with door open) 73.6 cm (W) x 81.4 cm (D) x 103.6 cm (H) x 151.8 cm (D with door open) Gas : 161.2lbs(73.1kg), Electrical : 155.4lbs(70.5kg) IEC 9.0 cu.ft(8lb/3.6kg)