LG DR1F9H Owners Manual - Page 49

Troubleshooting Check the following guide for the possible cause of a problem before contacting service. Symptom No power. No picture. No sound. The playback picture is poor. The recorder does not start playback. The picture from the external input is distorted Some channels are skipped over when using CH (+/-). The picture or sound of broadcasting channel is weak or missing. Camcorder image is not shown. Camcorder image via A/V input or DV IN to recorder is not shown on TV screen. Cause The power cord is disconnected. The TV is not set to receive recorder signal output. The video cable is not connected securely. The connected TV power is turned off. The equipment connected with the audio cable is not set to receive recorder signal output. The audio cables are not connected securely. The power of the equipment connected with the audio cable is turned off. The audio connecting cord is damaged. The disc is dirty. No disc is inserted. An unplayable disc is inserted. The disc is placed upside down. The disc is not placed within the guide. The disc is dirty. The Rating level is set. The video signal from the external component is copy-protected. Those channels are not stored in the recorder. Antenna or cables are loose. Camcorder is off. The recorder's source is incorrect. Solution Plug the power cord into the wall outlet securely. Select the appropriate video input mode on the TV so the picture from the recorder appears on the TV screen. Connect the video cable securely. Turn on the TV. Select the correct input mode on the audio receiver so you can listen to the sound from the recorder. Connect the audio cable securely. Turn on the equipment connected with the audio cable. Replace it with new one. Clean the disc. Insert a disc. (Check that the disc indicator in the display window is lit.) Insert a playable disc. (Check the disc type, color system, and regional code.) Place the disc with the playback side down. Place the disc on the disc tray correctly inside the guide. Clean the disc. Cancel the Rating function or change the rating level. You cannot connect via this recorder. Connect the component directly to your TV. Use the CH. Add/Del feature to restore channels. See [To Add or Erase Channels] on page 18. Tighten connections or replace cable. Turn camcorder on and operate properly. Use INPUT to select input channel (AV1, AV2, DV, etc.) Reference 49