LG GCC-H21N Installation Instructions - Page 1

Installing the Drive Before installing the drive, turn off the system power. Disconnect the power cord, and remove the cover. • Remove a vacant 5.25" drive bay panel from the computer. Slide the drive into the drive bay. Set the jumper on the rear of the drive as necessary. A. When using a Primary IDE port If you need to connect your drive to the same primary IDE channel as the hard drive, the drive should be set to SLAVE position. B. When using a Secondary IDE port ❶ If there is no device connected to the secondary IDE channel, connect the drive to this channel and set the jumper to MASTER. ❷ When two drives are connected, set one drive to MASTER and the other drive to SLAVE. If your operating system encounters interface problems after installing the new drive, try swapping the jumpers or move one drive to another IDE channel. Method A DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 CD Rewriter/DVD-ROM Drive CD Rewriter/DVD-ROM Drive Method B DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 CD Rewriter/DVD-ROM Drive CD Rewriter/DVD-ROM Drive DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 CD Rewriter/DVD-ROM Drive DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 First Drive Second Drive