LG JMC8130DDQ Installation Instructions - Page 2

Installation, Notes, Service - manual

Page 2 highlights

INSTALLATION 1. Cut hole in cabinet to mount Microwave oven. Cutout in cabinet should be level and straight. NOTE: There are no provisions to level the unit after it is installed. An oven that is not level could cause poor cooking results. 2. Install plywood floor as shown above. 3. Attach unit to the cabinet with 4 long oval head screws supplied inside of envelope containing these instructions. Pre-drill 4 holes in cabinet for attachment screws using 1/16² drill. Oven mounting holes are provided in side trim. 4. Attach the bottom grill, found in the upper packing materials, to the front plate with the 2 short truss head screws supplied in the envelope packaged with the bottom grill. 5. See Owner's Manual for operating instructions. NOTES S Do not build in above gas wall ovens due to placement of gas wall oven vent. Electrical rating of this oven: S 120 VAC @ 60 Hz. S 13 A / 1000 W S You need a DEDICATED 120 VAC, 60 Hz, 15 A or 20 A, fused electrical supply (located in the cabinet with the microwave as close as possible to the microwave) serving only the microwave. S Check with a qualified electrician if you are not sure whether the oven is properly grounded or if you do not completely understand the grounding instructions. S Do not use a fuse in the neutral or grounding circuit. S Save these instructions for the local electrical inspector's use. S If there is an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. S Place the plug into a properly installed and grounded outlet. S Maytag does not recommend use of an extension cord. S Keep the power cord dry and do not pinch or crush it. S Do not, under any circumstances, remove the power supply cord grounding prong! S This appliance MUST be grounded! SERVICE Interrupt the source of electricity to the unit when attempting to repair or service the oven. Failure to do this could result in a dangerous or even fatal shock. Dim "A" = With Warming Drawer = 69² Dim "A" = Without Warming Drawer = 59¼² Dim "A" = With Warming Drawer = 62½² Dim "A" = Without Warming Drawer = 59¼² SAME FOR BOTH WITH OR WITHOUT WARMING DRAWER Unit approved for use over the following wall ovens: JJW9530D JJW9527D JJW7530DD JJW8530D JJW8527D JWD7030CDX 2

  • 1
  • 2

2
INSTALLATION
1. Cut hole in cabinet to mount Microwave oven. Cutout in
cabinet should be level and straight.
NOTE: There are no provisions to level the unit after it
is installed. An oven that is not level could cause poor
cooking results.
2. Install plywood floor as shown above.
3. Attach unit to the cabinet with 4 long oval head screws
supplied inside of envelope containing these
instructions. Pre-drill 4 holes in cabinet for attachment
screws using 1/16
±
drill. Oven mounting holes are
provided in side trim.
4. Attach the bottom grill, found in the upper packing
materials, to the front plate with the 2 short truss head
screws supplied in the envelope packaged with the
bottom grill.
5. See Owner’s Manual for operating instructions.
NOTES
S
Do not build in above gas wall ovens due to placement
of gas wall oven vent.
Electrical rating of this oven:
S
120 VAC @ 60 Hz.
S
13 A / 1000 W
S
You need a
DEDICATED
120 VAC, 60 Hz, 15 A or 20
A, fused electrical supply (located in the cabinet with
the microwave as close as possible to the microwave)
serving only the microwave.
S
Check with a qualified electrician if you are not sure
whether the oven is properly grounded or if you do not
completely understand the grounding instructions.
S
Do not use a fuse in the neutral or grounding circuit.
S
Save these instructions for the local electrical
inspector’s use.
S
If there is an electrical short circuit, grounding reduces
the risk of electrical shock by providing an escape wire
for the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding plug.
S
Place the plug into a properly installed and grounded
outlet.
S
Maytag does not recommend use of an extension
cord.
S
Keep the power cord dry and do not pinch or crush it.
S
Do not, under any circumstances, remove the power
supply cord grounding prong!
S
This appliance
MUST
be grounded!
SERVICE
Interrupt the source of electricity to the unit when attempting
to repair or service the oven. Failure to do this could result
in a dangerous or even fatal shock.
Unit approved for use over the following wall ovens:
JJW9530D
JJW9527D
JJW7530DD
JJW8530D
JJW8527D
JWD7030CDX
Dim “A” = With Warming Drawer = 69
±
Dim “A” = Without Warming Drawer = 59¼
±
Dim “A” = With Warming Drawer = 62½
±
Dim “A” = Without Warming Drawer = 59¼
±
SAME FOR BOTH WITH OR WITHOUT
WARMING DRAWER