LG LBC22520TT Owner's Manual (English) - Page 11

REFRIGERATOR INSTALLATION REMOVING,REVERSING AND REPLACING REFRIGERATOR DOORS (For Drawer Type Models) 10 mm 1/4 in 3/8 in Hex head socket wrench TOOLS YOU MAY NEED No. 2 Phillips screwdriver Flat head screwdriver 1/4 in 3/32 in Allen wrench Other Important and necessary tools are: • 1/4 inch socket wrench • 10mm open-end wrench • Adjustable wrench • Flat 2-inch putty knife IMPORTANT: Before you begin, turn the refrigerator OFF and unplug it. Remove food and any adjustable door or utility bins from doors. HOW TO REVERSE DOOR OPENING DIRECT ION (when converting from the left-opening type to rightopening type) 1. Removing Refrigerator Door • Gently pry off the Top Hinge Cover with a flat head screwdriver and remove (1). • Using 10 mm socket wrench, remove the 3 bolts and lift off the Top Hinge. Set parts aside (2). • Lift the Refrigerator door (3) slightly and remove it. Pry off the cover (4) using a slotted screwdriver to find the hole screw and attach it on the right. Loosen the screws (5), remove the stopper (6) and attach them on the left (on the opposite side). Using a ¼-inch socket wrench, loosen and remove Hinge Pin (8) from the Middle Hinge Pin Bracket. 8 NOTE: At this point the door will be loose, lift up door slightly and remove it. • Loosen the 2 screws (9) and the 2 screws (10), and lift off the middle hinge (11). • Use a flat tip screwdriver to pry off bottom hole cover (7) and attach it on the right. HOW TO REMOVE DOOR HANDLES NOTE: Handle appearance may vary from illustrations on this page 2.Removing Refrigerator Handle • Loosen the set screws (1) with the 3/32" Allen wrench and remove the handle (2). • Loosen the handle mounting fasteners (3) with the 1/4" Allen wrench. • Carefully loosen the plug buttons with your fingers (4). The buttons can be unscrewed with your fingers, rotating the pieces counter clockwise, and then 4 the piece will be loose and fall. The buttons were installed without some pressure, for this reason the action can be done with your forefinger or thumb finger or with both. • Install the plug buttons (4) on the left side. • Install the handle mounting fasteners (3) on the right side.