LG LBN10551PV User Guide - Page 17

Reversing the doors is not covered by the warranty., After Completing the job - model #

Get LG LBN10551PV PDF manuals and user guides View all LG LBN10551PV manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Unscrew the dowel 22 of the lower hinge 23 turning it counter-clockwise and screw the dowel into the opposite hole. Unscrew the bolts 24 fixing the lower hinge 23 and bolt 25 on the refrigerator enclosure. Unscrew the screw 10 on the lower part of the door fixing the door closer 29 of the freezing compartment В . Unscrew the screw 10 on the lower part of the door fixing the door stop 9 of the freezing compartment В , move the stop 9 to the opposite side into the dedicated place and fix it. Rehinge the closer 29 to the opposite side into the dedicated place and fix it. Move the upper cap 26 to the opposite side. 16 18 17 19 26 23 22 24 B 9 25 29 10 5. Attach the removed lower hinge 23 to the holes located on the opposite side of the enclosure and fix the hinge with the bolts 24. Tighten the screw 25 in the enclosure on the opposite side. Install the door of the freezing compartment В onto the lower hinge dowel 23 . Unfold the removed middle hinge 18 with its axis out and fix the hinge with the bolts 17 (tighten the bolts carefully to exclude scratching of the door). Install the washer 16 onto the middle hinge 18 . 18 20 B 22 23 9 6. Install the door of the refrigeration compartment A aligning the hole in the lower part of the door and middle hinge dowel 18 . Then install the upper hinge 27 supplied in the refrigerator package placing the dowel into the appropriate upper hole in the door of the refrigeration compartment A . Connect the cable connectors 5 (only for models with an external display). Fix the upper hinge 27 using the bolts 3 . Install the left cover of the upper hinge 29 and fix it with the screw 2 . Install the blank 28 supplied in the refrigerator package. 2 29 3 27 28 For external display 5 10 After Completing the job Make sure that the four corners of the door gasket are not folded.It is recommended to apply a small amount of sillicon grease on them. Adjust the leveling screw on the bottom to the highest level so that the front side of the refrigrator is higher than the rear side. If you need assistance after switching the direction of the door opening as shown above, call a service center. Note Reversing the doors is not covered by the warranty. 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
16
Note
Reversing the doors is not covered by the warranty.
After Completing the job
Make sure that the four corners of the door gasket are not folded.It is recommended to
apply a small amount of sillicon grease on them.
Adjust the leveling screw on the bottom to the highest level so that the front side of the
refrigrator is higher than the rear side.
If you need assistance after switching the direction of the door opening as shown above,
call a service center.
Unscrew the dowel
of the lower hinge
turning it counter-clockwise and screw the
dowel into the opposite hole. Unscrew the
bolts
fixing the lower hinge
and
bolt
on the refrigerator enclosure.
Unscrew the screw
on the lower part of
the door fixing the door closer
of the
freezing compartment
. Unscrew the
screw
on the lower part of the door fixing
the door stop
of the freezing
compartment
, move the stop
to the
opposite side into the dedicated place and
fix it. Rehinge the closer
to the opposite
side into the dedicated place and fix it.
Move the upper cap
to the opposite side.
24
10
9
23
В
9
26
25
19
17
18
16
26
B
24
23
22
10
25
5. Attach the removed lower hinge
to the
holes located on the opposite side of the
enclosure and fix the hinge with the bolts
.
Tighten the screw
in the enclosure on the
opposite side. Install the door of the freezing
compartment
onto the lower hinge
dowel
. Unfold the removed middle
hinge
with its axis out and fix the hinge
with the bolts
(tighten the bolts carefully
to exclude scratching of the door). Install the
washer
onto the middle hinge
.
23
18
24
16
23
18
17
25
18
23
9
20
B
6. Install the door of the refrigeration
compartment
aligning the hole in the
lower part of the door and middle
hinge dowel
. Then install the upper
hinge
supplied in the refrigerator
package placing the dowel into the
appropriate upper hole in the door of the
refrigeration compartment
. Connect the
cable connectors
(only for models with an
external display). Fix the upper hinge
using the bolts
. Install the left cover of
the upper hinge
and fix it with the
screw
. Install the blank
supplied in
the refrigerator package.
28
29
A
3
18
5
2
27
27
A
29
3
2
27
5
10
28
For external display
22
29
10
29
29
В
22
23
В
9