LG LDF6810ST Owner's Manual - Page 16

U SING YOUR DISHWASHER Adding Rinse Aid to dispenser The purpose of rinse aids is to prevent possible spots on dishes formed from droplets during drying operation. By removing them, drying performance will be increased. NOTE Only liquid rinse aids can be used for this dishwasher. �Filling Rinse Aid 1. Rotate the round cap counterclockwise and remove it. �Rinse Aid Amount Setting The factory setting is at level 3 which is where you can expect the best performance under a normal condition. After a cycle is done, if you notice some spots, streaks or water marks on the dishes, adjust to a higher setting. If you notice foam present on the bottom of the glasses or tub bottom, change to a lower setting. 1. Remove the cap. 2. Rotate adjuster to the desired setting. USING YOUR DISHWASHER 2. Add a liquid rinse aid to the maximum level. (Max. 4.8 oz (145ml)) 3. Replace and lock the cap. 4. Rinse aid will be automatically dispensed during the final rinse cycle. �Refilling Rinse Aid 4.8 oz (145ml) is the capacity of the rinse aid dispenser. The refilling period totally depends on your washing habits such as the number of washes per month and which rinse aid setting you adjust to your washing conditions. The indicator light will inform you when there is insufficient rinse aid in the dispenser. The indicator light will stay on when you close the door to start a cycle. NOTE In hard water areas where it is not economical or practical to install a water softener, use GLASS MAGIC with each load to increase the effectiveness of the detergent. Pour 1/4 cup (4 tbsp) of GLASS MAGIC into the bottom of your dishwasher each time the dishwasher is used except Rinse Only. To remove film on dishwasher recommend that use White Vinegar and operate product at about 20ml(4 tbsp) or use the Tub clean detergent. 16