LG LRBCC1204S Owners Manual - Page 14
Connect the tubing to the refrigerator.
View all LG LRBCC1204S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 INSTALLATION 4 Fasten the shutoff valve. Fasten the shutoff valve to the cold water pipe with the pipe clamp. Pipe Clamp 7 Connect the tubing to the valve. Place the compression nut and ferrule (sleeve) for copper tubing onto the end of the tubing and connect it to the shutoff valve. Make sure the tubing is fully inserted into the valve. Tighten the compression nut securely. Saddle-Type Shutoff Valve Vertical Cold Water Pipe Saddle-Type Shutoff Valve Compression Nut NOTE •• Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and their use is not permitted in Massachusetts. Consult with your licensed plumber. 5 Tighten the pipe clamp. Tighten the clamp screws until the sealing washer begins to swell. Pipe Clamp Clamp Screw Inlet End Washer Packing Nut Outlet Valve Ferrule (sleeve) 8 Flush out the tubing. Turn the main water supply on and flush out the tubing until the water is clear. Shut the water off at the water valve after about one quart of water has been flushed through the tubing. NOTE •• Do not over tighten clamp or you may crush the tubing. 6 Route the tubing. Route the tubing between the cold water line and the refrigerator. Route the tubing through a hole drilled in the wall or floor (behind the refrigerator or adjacent base cabinet) as close to the wall as possible. NOTE •• Be sure there is sufficient extra tubing (about 8 ft. coiled into three turns of about 10 in. diameter) to allow the refrigerator to move out from the wall after installation. 9 Connect the tubing to the refrigerator. NOTE •• Before making the connection to the refrigerator, be sure that the refrigerator power cord is not plugged into the wall outlet. •• Remove the flexible plastic cap from the water valve. •• Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown.