LG LRFS28XBD Owners Manual - Page 60
Parts & Features
View all LG LRFS28XBD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
60 TROUBLESHOOTING Problem Water has bad taste or odor. Possible Cause & Solution Refrigerator was recently installed. • Dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air and contaminants from the system. Do not dispense the entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF. Parts & Features Problem Doors will not close correctly or pop open. Doors are difficult to open. Refrigerator wobbles or seems unstable Lights do not work. Refrigerator has an unusual odor. Possible Cause & Solution Food packages are blocking the door open. • Rearrange food containers to clear the door and door shelves. Ice bin, crisper cover, pans, shelves, door bins, or baskets are out of position. • Push bins all the way in and put crisper cover, pans, shelves and baskets into their correct positions. See the Operation section for more information. The doors were removed during product installation and not properly replaced. • Remove and replace the doors according to the Removing and Replacing Refrigerator Handles and Doors section. Refrigerator is not leveled properly. • See Door Alignment in the Refrigeration Installation section to level refrigerator. The gaskets are dirty or sticky. • Clean the gaskets and the surfaces that they touch. Rub a thin coat of appliance polish or kitchen wax on the gaskets after cleaning. Door was recently closed. • When you open the door, warmer air enters the refrigerator. As the warm air cools, it can create a vacuum. If the door is hard to open, wait one minute to allow the air pressure to equalize, then see if it opens more easily. Leveling legs are not adjusted properly. • Refer to the Leveling and Door Alignment section. Floor is not level. • It may be necessary to add shims under the leveling legs or rollers to complete installation. LED interior lighting failure. • The refrigerator compartment lamp is LED interior lighting, and service should be performed by a qualified technician. LED door lighting failure (on some models). • The proximity sensor is located in the center of the door, and may not sense activity to the side of the door. The proximity sensor must detect a person before it will operate the LED Lighting. If the flooring material is highly reflective, or if there are highly reflective objects in front of the product, the proximity sensor which controls the LED door lighting may not function properly. • It may take 30 seconds to work normally after the refrigerator is initially installed. The Air Filter may need to be set to the MAX setting or replaced. • Set the Air Filter to the MAX setting. If the odor does not go away within 24 hours, the filter may need to be replaced. See the Replacing the Air Filter section for replacement instructions.