LG LRFXS2503D Owners Manual - Page 43

Air Filter, Water Filter

Page 43 highlights

ENGLISH Air Filter Replacing the Fresh Air Filter Replace the Fresh Air Filter: • Approximately every six months. • When the Replace Filter g icon turns on. • Use replacement air filter: LT120F 1 Rotate the filter cover counterclockwise to release the tabs, and remove the cover. MAINTENANCE 43 6 Press and hold the Fresh Air Filter button on the control panel for 3 seconds to reset the filter sensor. 2 Remove the filter from the inside of the cover by pressing the side of the filter in and pulling the center out. 3 Place the new filter inside of the cover with the side that says FRONT facing outward. 4 Align tabs a on the filter cover with hooks b on the refrigerator wall. 5 Rotate the air filter cover clockwise until the hooks engage and the cover locks in place. Water Filter Before Replacing the Water Filter WARNING • To reduce the risk associated with choking, do not allow children under 3 years of age to have access to small parts during the installation of this product. • To reduce the risk associated with the ingestion of contaminants, do not use with water that is microbiologicallyunsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts. EPA Establishment # 070595MEX-001 • Use of unauthorized water filters may result in product malfunction, water leakage or water quality issues, which will not be covered under the product warranty. CAUTION • Read and follow Use Instructions before installation and use of this system. • Installation and use MUST comply with all state and local plumbing codes. • Do not install if water pressure exceeds 120 psi (827 kPa). If your water pressure exceeds 80 psi, you must install a pressure limiting valve. Contact a plumber if uncertain how to check your water pressure. • Do not install where water hammer conditions may occur. If water hammer conditions exist you must install a water hammer arrester. Contact a plumbing professional if you are uncertain how to check for this condition.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68

43
MAINTENANCE
ENGLISH
Air Filter
Replacing the Fresh Air Filter
Replace the Fresh Air Filter:
Approximately every six months.
When the
Replace Filter
g
icon turns on.
Use replacement air filter: LT120F
1
Rotate the filter cover counterclockwise to
release the tabs, and remove the cover.
2
Remove the filter from the inside of the cover
by pressing the side of the filter in and pulling
the center out.
3
Place the new filter inside of the cover with
the side that says
FRONT
facing outward.
4
Align tabs
a
on the filter cover with hooks
b
on the refrigerator wall.
5
Rotate the air filter cover clockwise until the
hooks engage and the cover locks in place.
6
Press and hold the
Fresh Air Filter
button on
the control panel for 3 seconds to reset the
filter sensor.
Water Filter
Before Replacing the Water Filter
WARNING
To reduce the risk associated with choking, do
not allow children under 3 years of age to have
access to small parts during the installation of
this product.
To reduce the risk associated with the ingestion
of contaminants, do not use with water that is
microbiologicallyunsafe or of unknown quality
without adequate disinfection before or after the
system. Systems certified for cyst reduction may
be used on disinfected water that may contain
filterable cysts. EPA Establishment # 070595-
MEX-001
Use of unauthorized water filters may result in
product malfunction, water leakage or water
quality issues, which will not be covered under
the product warranty.
CAUTION
Read and follow Use Instructions before
installation and use of this system.
Installation and use MUST comply with all state
and local plumbing codes.
Do not install if water pressure exceeds 120 psi
(827 kPa). If your water pressure exceeds 80 psi,
you must install a pressure limiting valve.
Contact a plumber if uncertain how to check
your water pressure.
Do not install where water hammer conditions
may occur. If water hammer conditions exist you
must install a water hammer arrester. Contact a
plumbing professional if you are uncertain how
to check for this condition.