LG LRMVS3006S Owners Manual - Page 14
Removing/Assembling, Handles
View all LG LRMVS3006S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 INSTALLATION Removing/Assembling Handles When moving the refrigerator through a narrow opening, removing the doors is preferred. If you must remove the handles, be very careful not to scratch the doors. The appearance of the handles may vary from what is shown. CAUTION • When assembling or disassembling the refrigerator handles, grasp the handle firmly to avoid dropping it. • Do not swing the handle into nearby people or animals. • Make sure that the set screws are in place and the handle footprints at the ends of the handles are aligned correctly over the mounting fasteners on the doors. The set screws should be loose enough to allow the handle footprints to slide down into place over the mounting fasteners on the door. • Make sure that there is not a gap between the door and handle after assembling the handle. • Tools Needed - 3/32 in. Allen wrench - 1/8 in. Allen wrench - 1/4 in. Allen wrench Removing Refrigerator Handles 1 Loosen the set screws a with a 3/32 in. Allen wrench and remove the handle. 2 If needed, loosen the mounting fasteners b that connect the refrigerator door and handle using a 1/4 in. Allen wrench, and remove the mounting fasteners. Assembling Refrigerator Handles 1 If needed, reassemble the mounting fasteners a on the door with a 1/4 in. Allen wrench. 2 Place the handle on the door by fitting the handle footprints over the mounting fasteners and tightening the set screws b with a 3/32 in. Allen wrench. Removing Freezer Drawer Handles 1 Loosen the set screws a located on the lower side of the handle with a 1/8 in. Allen wrench and remove the handle. 2 Loosen the mounting fasteners b with a 1/4 in. Allen wrench, and remove the mounting fasteners. Assembling Freezer Drawer Handles 1 Assemble the mounting fasteners a at both ends of the handle with a 1/4 in. Allen wrench. 2 Place the handle on the door by fitting the handle footprints over the mounting