LG LRSC26980SB User Guide - Page 25

How to Dismantle Parts

Page 25 highlights

How to Dismantle Parts Freezer Compartment Lamp To remove the lampcover pull out firmly on the lamp cover and rotate.This should expose the bulb. Turn the bulb counterclockwise,Max. 40 W refrigerator bulb is used and can be purchased at a service center. Dispenser Lamp Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W refrigerator bulb is used and can be purchased at a service center. Freezer Compartment Shelf To remove a shelf, lift the left part of the shelf a bit, push it to direction 0, lift the right part to direction ®, and take it out. Door Rack and Support Lift the door rack holding both sides (b and pull it in direction ®. Ice Storage Bin Hold the ice storage bin as shown in the figure to the right and pull it out ® while slightly lifting it¢. • It is recommended not to dismantle the ice storage bin unless it is necessary. • Use both handsto remove the ice bin to avoid dropping it. • If the ice bin does not slide into place easily, twist the drive device slightly. After Dispenser Is Used The water collector has no self-drainage function. It should be cleaned regularly. Remove the cover by pulling the front side of water collector cover and dry it with a cloth. Drive Device

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33

Freezer
Compartment
Lamp
Dispenser
Lamp
Freezer
Compartment
Shelf
Door
Rack and
Support
Ice Storage
Bin
After
Dispenser
Is Used
How to Dismantle Parts
To remove the lampcover pull out firmly on the
lamp cover and rotate.This should expose the bulb.
Turn the bulb counterclockwise,Max. 40 W
refrigerator bulb is used and can be purchased at a
service center.
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W refrigerator bulb
is used and can be purchased at a service
center.
To remove a shelf, lift the left part of the shelf
a bit, push it to direction 0, lift the right part to
direction ®, and take it out.
Lift the door rack holding both sides (b and
pull it in direction ®.
Hold the ice storage bin as shown in the figure
to the right and pull it out ® while slightly lifting
it¢.
• It is recommended not to dismantle the ice
storage bin unless it is necessary.
• Use both handsto remove the ice binto avoid
dropping it.
• If the ice bin does not slide into place easily,
twist the drive device slightly.
The water collector has no self-drainage
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
Drive
Device