LG LRSC26980TT User Guide - Page 25

Care and Maintenance How to Dismantle Parts NOTE • Dismantling is done in the reverse sequence of assembly. Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged. Freezer Compartment Lamp To remove the lamp cover pull out firmly on the lamp cover and rotate. This should expose the bulb. Turn the bulb counterclockwise. Max. 40 W refrigerator bulb is used and can be purchased at a service center. 1 2 3 Dispenser Lamp Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W refrigerator bulb is used and can be purchased at a service center. Freezer Compartment Shelf To remove a shelf, lift the left part of the shelf a bit, push it to direction , lift the right part to direction , and take it out. EXPRESS/JET FRZ DISPENSER FREEZER REFRIGERATER FILTER/LIGHT LOCK 1 2 Door Rack and Lift the door rack holding both sides and Support pull it in direction . Ice Storage Bin Hold the ice storage bin as shown in the figure to the right and pull it out while slightly lifting it . It is recommended not to dismantle the ice storage bin unless it is necessary. Use both hands to remove the ice bin to avoid dropping it. If the ice bin does not slide into place easily, twist the drive device slightly. After Dispenser Is Used The water collector has no self-drainage function. It should be cleaned regularly. Remove the cover by pulling the front side of water collector cover and dry it with a cloth. 25