LG LSXS22423B Owners Manual - Page 14

14 INSTALLATION ENGLISH Removing the Right (Refrigerator) Door wire harness 1. Open the door. Remove the top hinge cover screw. 2. Use a flat blade screwdriver to pry back the hooks (not shown) of the hinge cover from the top of the refrigerator cabinet. Lift up the cover. Disconnect all wire harnesses. upper hinge hinge lever 3. Rotate the hinge lever clockwise (1). Lift the upper hinge free of the hinge lever latch (2). CAUTION When lifting the hinge free of the latch, be careful that the door does not fall forward. 4. Lift the door from the lower hinge pin. Reinstalling the Right (Refrigerator) Door 1. Place the door onto the lower hinge pin. 2. Fit the upper hinge over the hinge lever latch and into place. Rotate the lever counterclockwise to secure the hinge. 3. Reconnect all wire harnesses. Hook the tab on the switch side of the cover under the edge of the wire opening in the cabinet top. Position the cover and replace the screw. Reinstalling the Left (Freezer) Door 1. Feed the water tubes through the lower hinge pin and place the door onto the lower hinge pin. Water hoses should be behind the leg to prevent damage. 2. Fit the top hinge over hinge lever latch and into place. Rotate the lever clockwise to secure the hinge. 3. Install the grounding screw and connect all the wire harnesses. 4. Hook the tab on the door switch side of the cover under the edge of the wire opening in the cabinet top. Position the cover into place. Insert and tighten the cover screw. 5. Reconnect the water tubes by inserting the tubes into the connectors. The tube is inserted correctly when only one guide line is showing out of two. lower hinge 5. Place the door, inside facing up, on a nonscratching surface. Collet Tube Insert Line NOTE  Do not remove the grease on the surface of the gasket or hinge.  Do not remove the sensor assembly in the right upper hinge cover. NOTE  Water hoses should be cut with a clean, straight edge to avoid leaks. Not Straight Damaged Stretched