LG LTRM1240SB Owner's Manual - Page 24

TROUBLESHOOTING ENGLISH Questions and Answers Operation Question Why is the oven light not on during cooking? Why does steam come out of the air exhaust vent? Answer There may be several reasons why the oven light is not on. Have you: • Set a cooking time? • Touched START? Steam is normally produced during cooking. The microwave oven has been designed to vent this steam. Will the microwave oven be damaged if it Yes. Never operate the oven empty or without the glass turntable. operates empty? Does microwave energy pass through the viewing screen in the door? No. The metal screen bounces the energy back to the oven cavity. The holes (or ports) allow only light to pass through. They do not let microwave energy pass through. Why does a tone sound when a pad on the control panel is touched? The tone tells you that the setting has been entered. Can my microwave oven be damaged if food is cooked for too long? Like any other cooking appliance, it is possible to overcook food to the point that the food creates smoke, and even possibly fire and damage to the inside of the oven. It is always best to be near the oven while you are cooking. When the oven is plugged into a wall outlet for the first time, it does not work properly. What is wrong? The microcomputer controlling your oven may temporarily become scrambled and fail to function as programmed when you plug it in for the first time or when power resumes after a power interruption. Unplug the oven from the 120~ volt household outlet and then plug it back in to reset the microcomputer. Why do I see light reflection around the outer case? This light is from the oven light which is located between the oven cavity and the outer wall of the oven. What are the various sounds I hear when the microwave oven is operating? The clicking sound is caused by a mechanical switch turning the microwave oven's magnetron ON and OFF. The heavy hum and clunk is from the change in power the magnetron draws as it is turned ON and OFF by a mechanical switch.The change in blower speed is from the change in line voltage caused by the magnetron being turned ON and OFF. Why does a fan sound for some time after The fan blowing cools the toaster heater for about 1 minute after toasting? toasting. This is normal. What does "HOT" code on the display mean? If you operate toaster several times using one slot continuously, the toaster's internal temperature will be hot and may cause "Hot" to appear in the display. This will go away after several minutes after the toaster cools down. CAUTION: Do not operate toaster without bread. What does "F-1" and "F-2" code on the display mean? That means failure mode. Contact the nearest Authorized Service Center. 24