LG LW1014ER Owners Manual - Page 22
See Air Conditioner Freezing Up below.
View all LG LW1014ER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Air conditioner does not start The air conditioner is unplugged. The fuse is blown/circuit breaker is tripped. Make sure the air conditioner plug is pushed completely into the outlet. Check the house fuse/circuit breaker box and replace the fuse or reset the breaker. Power failure. The current interrupter device is tripped. If power failure occurs, turn the mode control to Off. When power is restored, wait 3 minutes to restart the air conditioner to prevent tripping of the compressor overload. Press the RESET button located on the power cord plug. If the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician. Air conditioner Airflow is restricted. does not cool as it should The temp control may not be set correctly. The air filter is dirty. The room may have been hot. Cold air is escaping. Cooling coil have iced up. Make sure there are no curtains, blinds, or furniture blocking the front of the air conditioner. In COOL modelđpress the DECREASE pad. Clean the filter at least every 2 weeks. See the care and Maintenance section. When the air conditioner is first turned on, you need to allow time for the room to cool down. Check for open furnace floor registers and cold air returns. See Air Conditioner Freezing Up below. Air conditioner The cooling coils are iced Ice may block the air flow and obstruct the air freezing up over. conditioner from properly cooling the room. Set the mode control at High Fan or High Cool. Water drips outside Water drips indoors Hot, humid weather. The air conditioner is not tilted to the outside. This is normal. For proper water disposal, make sure the air conditioner slants slightly from the case front to the rear. Water collects Moisture removed from air This is normal for a short period in areas with in base pan and drains into base pan. little humidity; normal for a longer period in very humid areas. Air conditioner Dirty air filter - air restricted. Clean air filter. turns on and off rapidly. Outside temperature extremely hot. Set FAN speed to a faster setting to bring air through cooling coils more frequently. Noise when Air movement sound. unit is cooling. Window vibration - poor installation. This is normal. If too loud, set to lower FAN setting. Refer to installation instructions or check with installer. Remote Sensing Deactivating Prematurely. Remote control not located Place remote control within 20 feet & 120° radius within range. of the front of the unitē Remote control signal obstructed. Remove obstruction. Room too cold. Set temperature too low lncrease set temperature. You can refer to the Energy Star program in detail at www.energystar.gov. If you see "CH" in the display, please call 1-800-243-0000. 22