LG LW1214ER Owners Manual - Page 17

Dry - Dry mode is used to remove humidity from the room without additional cooling. Once the set temperature is reachedđthe compressor and circulation fan turns off. Fan speed is pre-set and cannot be adjusted. TEMPERATURE CONTROL The thermostat monitors room temperature to maintain the desired temperature. The thermostat can be set between 60 F~86 F (16 C~30 C). REMOTE CONTROL SENSOR 7 CLEAN FILTER 'Clean Filter' LED will light up to notify you that your filter needs to be cleaned. After cleaning the filter, press "Temp " together to turn off 'Clean Filter' light. (Filter reset must be done from unit control panel not remote control). This feature is reminder to clean the Air Filter (See Maintenance) for more efficient operation. The LED (light) will illuminate after 250 hours of operation. During operation in failure of electric power, the unit runs as previous setting operation. EENNEERRGGYY SSAAVVEERR The unit defaults to Energy Saver mode each time the unit is switched on except restoration after an electrical power outage and fan mode. CAUTION The remote controller will not function properly if strong light strikes the sensor of the air conditioner or if there are obstacles between the remote controller and the air conditioner. 1. Push out the cover on the back of the remote control with your thumb. 2. Pay attention to polarity and insert one new AAA 1.5V battery. 3. Reattach the cover. Do not use rechargeable battery. Make sure that the battery is new. Do not mix alkaline, standard (Carbon-zinc) or rechargeable (Nickel-cadmium) battery. - In order to prevent discharge, remove the battery from the remote control if the air conditioner is not going to be used for an extended period of time. Keep the remote control away from extremely hot or humid places. To maintain optimal operation of the remote control, the remote sensor should not be exposed to direct sunlight.