LG LW1817IVSM Owners Manual - Page 17

OPERATION 17 EN 6 Clean Filter The Clean Filter LED lights up to notify you Temp and together on the control panel to turn off the Clean Filter light. NOTE ● control panel, not the remote control. ● This feature is a reminder to clean the air Using the Light Off Function You can set the brightness of the control panel, ● Press Mode button on the remote control for 3 seconds, or ● Press Mode and Sleep button together on the control panel. NOTE ● Turn on/off the control panel. light turns on after 250 hours of operation. 7 Fan Speed Press to set the fan speed to Low (F1), Medium (F2), or High (F3). 8 Temperature Control The thermostat monitors room temperature to maintain the desired temperature. The thermostat can be set between 60 °F-86 °F (16 °C-30 °C). Press or arrows to increase or decrease temperature setting. 9 Energy Saver In this mode the compressor and fan turn off when the set temperature is achieved. Approximately every 3 minutes the fan turns on to allow the unit sensor to accurately determine if more cooling is needed. 10 Clear Cancel Sleep and Timer settings. Using the Auto Clean Function In the Cooling and Dry Mode, Moisture is generated inside the indoor unit. This function removes such moisture. ● Press Energy Saver button on the remote control for 3 seconds. ● is displayed on the remote control. NOTE ● If you turn off the unit, the fan continues to run for 10 minutes and cleans the inside of the indoor unit. NOTE ● Auto Restart: If the air conditioner turns off due to a power outage, it will restart automatically once the power is restored, with the same settings as were set before the unit turned off. ● Energy Saver: The unit defaults to the Energy Saver mode each time the unit is switched on except in Fan mode or when power is restored after an electrical power outage. ● The remote control will not function properly if the AC infrared sensor is exposed to direct light or if there are obstacles between the remote controller and the air conditioner.