LG MB-387W Service Manual - Page 16
K. Pcb Assembly Removal, L. Interlock System
View all LG MB-387W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
K. PCB ASSEMBLY REMOVAL 1) Remove the control panel assembly from the cavity. (Refer to control panel assembly removal on previous page.) 2) Remove screws which hold the PCB SUB ASS'Y to the control panel. 3) Disconnect the flat cable from the PCB SUB ASS'Y and take off the PCB SUB ASS'Y. L. INTERLOCK SYSTEM 1) INTERLOCK MECHANISM The door lock mechanism is a device which has been specially designed to eliminate completely microwave activity when the door is opened during cooking and thus to prevent the danger resulting from the microwave leakage. 2) MOUNTING OF THE PRIMARY/MONITOR/ SECONDARY SWITCHES TO THE LATCH BOARD ADJUSTMENT DIRECTION PRIMARY SWITCH MONITOR SWITCH SECONDARY SWITCH 3) INSTALLATION AND ADJUSTMENT OF THE LATCH BOARD TO THE OVEN ASSEMBLY • Mount the latch board to the oven assembly. • Adjust the latch board in the arrow direction so that oven door will not have any play in it when the door is closed. • Tighten the mounting screw. • Check for play in the door by pushing the door release button. Door movement should be less than 0.5 mm. (1/64 inch) Don't push the door release button while making adjustment. Make sure that the latch moves smoothly after adjustment are completed and that the screws are tight. Make sure the primary, monitor, and secondary switches operate properly by following the continuity test procedure. FIG. 1 CAUTION: CHECK THE CORRECT POSITION MAGNETRON H.V. TRANSFORMER PRIMARY 5-6 H.V.FUSE H.V. DIODE H.V. CAPACITOR