LG WD Owners Manual - Page 9

nstallation • Normal Tap without thread & screw type inlet hose 1. Unscrew the fixing screw to attach the tap. Ulerw Conneeeor Foondscrow Rubber peeldng 2. Push the connector up till the 3. Push the water supply hose rubber packing is in tight contact vertically upwards so that the with the tap. Then tighten the 4 rubber packing within in the screws. hose can adhere completely to the tap and then tighten it by Rubber pecking screwing it to the right. Upper Connector Upper Connector - PM Klatt supply hoe* • Normal Tap without thread & one touch type inlet hose 1. Untighten the upper connector screw. Ribber CoCro ector . . err'''. 'padthg Fang screwid-T:Sswte:,SicA-.,eviola comelier • In case the diameter of the tap is large remove the guide plate. 2. Push the upper connector up till 3. Connect the water supply hose the rubber packing is in tight to the middle connector, contact with the tap. Then pushing the plate down. tighten the 4 screws. Rubber racking Upper \ Connector, widdlo connects Cuoonsneector Plate Water supply hose Guide plate Connecta • Turn the middle connector not to have water leaked. • Make sure that the rubber seal is inside the hose connector. • To separate the water supply hose from the middle connector shut off the tap. Then pull the inlet hose down, pushing the plate down. Used the horizontal tap Horizontal tap Extension tapt rz-___ nose connector Square tap Rubber seal • Your machine comes with only cold water connection. • Make sure that there are no kinks in the hose and that it is not crushed. 9