LG WM2455HG Owner's Manual (English) - Page 18
Optional Accessories - parts
UPC - 048231009171
View all LG WM2455HG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
OPTIONAL ACCESSORIES PEDESTAL ACCESSORY The pedestal accessory includes: • Pedestal base • Eight (8) screws • One (1) drawer divider • Wrench • Four (4) brackets Tools Needed for Installation: • Phillips-head screwdriver • Wrench (supplied) PEDESTAL INSTALLATION To ensure safe and secure installation, please thoroughly follow the instructions below. wWARNING • Incorrect installation can cause serious accidents. • The appliances are heavy. Two or more people are required when installing the pedestal. There is a risk of serious back injury or other injuries. • Do not allow children to play in or on the drawer. There is a risk of suffocation or injury. • Do not step on the handle. There is a risk of serious injury. • If appliances are already installed, disconnect them from all power, water, or gas lines and from draining or venting connections. Failure to do so can result in electrical shock, fire, explosion, or death. For dryer For washer/combo 1 Make sure the leveling feet of the appliance are fully retracted (see detail for leveling washer feet in Step 2); then position the appliance on top of the pedestal. The washer feet will fit into the outermost corner positions and the dryer feet will fit into the innermost positions as shown. NOTE: The appliance and pedestal assembly must be placed on a solid, sturdy, level floor for proper operation. 34 MFL31245113_ENG.indd 34-35 Tighten all 4 locknuts securely 2 Once the leveling feet of the washer are fully retracted, tighten all locknuts securely. NOTE: The leveling feet on the dryer do not have locknuts. OPTIONAL ACCESSORIES PEDESTAL INSTALLATION (cont.) 3 Make sure the side surface of the appliance is clean and dry. Remove paper backing from the tape on the bracket. 4 Position the bracket as shown. The bent part of the bracket should rest along the edge of the pedestal, and the holes in the bottom part of the bracket should align with the holes in the pedestal. 5 Install 2 screws to securely attach the bracket to the pedestal. Once properly attached, firmly press the top part of the bracket with the double-sided tape to the side of the appliance. Repeat steps 2-4 to attach the other brackets. NOTE: If the brackets are not installed properly, noise and vibration may result. Be sure to remove paper backing and to use all screws to install the brackets. Move the appliance to the desired location. Raise Lower 6 Loosen the locknuts on all 4 leveling feet of the pedestal until you can turn them with the wrench. Turn clockwise to raise or counterclockwise to lower. Once the pedestal is level and all 4 feet are solidly against the floor, securely tighten all locknuts by hand. NOTE: Noise and vibration may result if locknuts are not tightened. Be sure to connect the appliances to all water, power, or gas lines and draining or venting connections before operation. If there is excessive vibration during the first operation after installation, slightly adjust the leveling feet. 35 2007.10.4 2:32:11 PM