LG WM3001HPA Owner's Manual - Page 11

INSTALLATION INSTRUCTIONS UNPACKING AND REMOVING SHIPPING BOLTS When removing the washer from the carton base, be sure to remove the foam tub support in the middle of the carton base. If you must lay the washer down to remove the base packaging materials, always lay it carefully on its side. Do NOT lay the washer on its front or back. IMPORTANT: To prevent internal damage during transport, the washer is equipped with 4 shipping bolts and plastic retainers. These bolts and retainers MUST be removed before operating the washer. • Failure to remove shipping bolts and retainers may cause severe vibration and noise, which can lead to permanent damage to the washer. The cord is secured to the back of the washer with a shipping bolt to help prevent operation with shipping bolts in place. Foam Tub Support Carton Base Shipping Bolts Retainer 1 Starting with the bottom 2 shipping bolts, use the included wrench to remove the 4 shipping bolts by turning them counterclockwise. w WARNING To reduce the risk of injury to persons when using this cleaner, follow basic To reduce the risk of fire when using and install this appliance follow basic precautions, including the following : • Do not install nearby heat item. Such as stove, cooking oven. Failure to do so can cause deform, smoke and fire. • Do not place candle and cigarettes on top of the product. Failure to do so can cause deform, smoke and fire. • Remove all protective vinyl film from the product. Failure to do so can cause deform, smoke and fire. Removing the Protective Film The front of the washer are covered with a protective vinyl film. This film is to protect the finish during shipping, and should be removed before use. Hole Cap 2 Remove the retainers by turning them slightly while pulling. Rotate and press the hole caps into the shipping bolt holes. NOTE: Save the bolts and retainers for future use. To prevent damage to internal components, the shipping bolts and retainers must be installed when transporting the washer. 11