LG WM9000HVA Owners Manual - English - Page 18
Leveling the washing machine
View all LG WM9000HVA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
18 INSTALLATION INSTRUCTIONS Leveling the washing machine The washer tub of your new washing machine spins at very high speeds. To minimize vibration, noise, and unwanted movement, the floor must be perfectly level and solid. 1 Check the washing machine's level. - Check the precise level by rocking the top edges of the washing machine or placing a level on the washing machine. The slope beneath the washing machine must not exceed 1°, and all four leveling feet must rest firmly on the floor. Level 1° 4 Check the washing machine's level again. - Push or rock the top edges of the washing machine gently to make sure that the washing machine does not rock. - If the washing machine rocks, repeat steps 1 to 3. WARNING yy Using the washing machine without leveling, it may result in malfunction caused by the production of excess vibration and noise. yy If you are installing the washing machine on the optional pedestal, you must adjust the leveling feet on the pedestal to level the washing machine. The washing machine´s leveling feet should be minimized and turn the locknuts counterclockwise to secure. yy Use the leveling feet only when you level the washing machine. If you raise the leveling feet unnecessarily, it may cause abnormal vibration of the washing machine. 2 Turn the lower leveling feet clockwise to level the washing machine. - Turning the lower leveling feet clockwise raises the washing machine. Raise 3 Turn the locknuts counterclockwise and tighten them when the washing machine is level. Using non-skid pads (optional) If you install the washing machine on a slippery surface, it may move because of excessive vibration. Incorrect leveling may cause malfunction through noise and vibration. In the event of this, lay the nonskid pads under the leveling feet and adjust the level. 1 Clean the floor to attach the non-skid pads. - Use a dry rag to remove and clean foreign objects or moisture. If moisture remains, the non-skid pads may slip. 2 Adjust the level after placing the washing machine in the installation area. 3 Place the adhesive side of the non-skid pad on the floor. - It is most effective to install the non-skid pads under the front legs. If it is hard to place the pads under the front legs, place them under the back legs. This side up Tighten all 4 lock nuts securely using the wrench. Adhesive side Remove backing 4 Check the washing machine's level again. - Push or rock the top edges of the washing machine gently to make sure that the washing machine does not rock. If the washing machine rocks, level the washing machine again.