Lantronix SISPM1040-3166-L SISPM1040-3166-L Datasheet - Page 1

Lantronix SISPM1040-3166-L Manual

Page 1 highlights

SISPM1040-3166-L Managed Hardened Gigabit Ethernet PoE+ Rack Mountable Switch (16) 10/100/1000Base-T PoE+ Ports + (4) 100/1000Base-X SFP Slots + (2) 1G/10GBase-X SFP+ Slots Features ● IPv4/IPv6 dual protocols ● Supports Jumbo Frame up to 9K bytes ● Authentication - RADIUS, TACACS+ ● DHCP Relay, DHCP Snooping, DHCP Server ● L2/L3/L4 ACLs Support MAC, VLAN ID, or IP address, protocol, per port ● LLDP (Link Layer Discovery Protocol) ● ITU-T G.8031 Ethernet Linear Protection ● ITU-T G.8032 Ethernet Ring Protection Switching ● Rapid Ring for fast recovery ● IEEE 802.3az Energy Efficiency ● IP Source Guard, Port Security ● Port Mirroring ● Syslog ● Static Routing, 130 rates (max) ● Fanless Design ● Media Redundancy Protocol (MRP) PoE Features ● Compliant with IEEE 802.3at PoE+ ● Compliant with IEEE 802.3af PoE ● IEEE 802.1AB LLDP-MED Configuration ● PoE Configuration ● PoE Scheduling ● Power Delay ● Auto Power Reset ● DHCP per Port ● Always on PoE Device Management System (DMS) ● Graphical Monitoring - Topology view, Floor view, Map view ● Traffic Monitoring ● Troubleshooting - Network diagnostic, protection mechanism, performance and link management This switch is a next generation rack mountable hardened switch with 80Gbps switching capacity. It provides (16) 10/100/1000 PoE+ ports, (4) 100/1000 dual speeds SFP ports and has (2) additional 1G/10G SFP+ slots. Specifications Standards IEEE 802.3 IEEE 802.3u IEEE 802.3z IEEE 802.3ae IEEE 802.3x IEEE 802.3ad IEEE 802.1D IEEE 802.1w IEEE 802.1s IEEE 802.1Q IEEE 802.1p IEEE 802.1ad IEEE 802.1AB IEEE 802.3af IEEE 802.3at IEEE 802.3az IEEE 802.3ah IEEE 802.1ag IEC 62439-2 Protocols CSMA/CD Technology Store-and-forward switching architecture Connectors (16) 10/100/1000 Mbps RJ-45 ports (4) 100/1000 Mbps SFP slots (2) 1G/10G SFP+ slots (1) Console RJ-45 port MAC Address 32K MAC address table Backplane 80 Gbps Digital Output 24 VDC / 1A (Relay) Digital Input Level 0 (low): 0V to 6V Level 1 (high): 10V to 24V Dimensions Width: 17.4" [442 mm] Depth: 11.81" [300 mm] Height: 1.73" [44 mm] Power Input 52 - 57VDC Dual Input Terminal Block or Single Input 100 - 250VAC Maximum Power Consumption (without PoE): 36 Watts Power-over-Ethernet Max PoE Budget 250 Watts (PoE power not available with use of AC power supply) 15 Watts for (16) ports simultaneously 30 Watts for (8) ports simultaneously Ingress Protection IP30 Environment Operating: -40°C to +75°C (1G SFPs) Operating: -40°C to +60°C (10G SFPs) Humidity: 5% to 95% (non-condensing) Altitude: 0 - 10,000 ft. Weight 10.58 lbs. [4.8 kg] Certifications FCC Class A; CE; NEMA TS-2, UL Safety: LVD Compliant * (Designed to Meet) IEC61850-3, IEEE 1613, Class 1 Div 2 Warranty 5 Years *Please contact sales with certification needs Ordering Information SISPM1040-3166-L (16) 10/100/1000Base-T PoE+ ports + (4) 100/1000Base-X SFP slots ports + (2) 1G/10GBase-X SFP+ slots 52V - 57 VDC or 100V - 250VAC Optional Accessories (sold separately) SFP and SFP+ Modules EDCA-DIO-01 Enclosure Door Contact Alarm Industrial Power Supplies (sold separately) 25104 Input: 85-264 VAC, 124-370 VDC Output: 48 ~ 55 VDC, 5A, 240 Watts 25160 Input 90-264 VAC, 127-370 VDC Output: 48 ~ 55 VDC, 10A, 480 Watts Software Features ● Management: Web Management, SNMP V1/V2c/V3, SSH, CLI ● Port Trunk: Supports IEEE 802.3ad port trunk with link aggregation control protocol (LACP) and static trunk ● Multicast: Support IGMP Snooping V1/ V2/V3, MVR, MLD Snooping V1/V2 ● Quality of Service: Supports 8 hardware queues. Strict priority and WRR, Ingress policer, Egress shaping and per port rate control ● Spanning Tree: Supports IEEE 802.1s MSTP, IEEE 802.1w RSTP and IEEE 802.1D STP Compliant ● VLAN: Port Based VLAN, IEEE 802.1Q tag-based, up to 4k VLAN entries, Q-in-Q, MAC-based VLAN, Management VLAN, Voice VLAN, Private VLAN ● Firmware Update through TFTP and HTTP/HTTPs ● E-Line, E-LAN, E-TREE, E-ACCESS, IEEE 802.3ah, IEEE 802.1ag, ITU-T Y.1731, Y.1564 ● Support IEEE 1588 v2 PTP (TC) 040822

  • 1

Ordering Information
SISPM1040-3166-L
(16) 10/100/1000Base-T PoE+ ports
+ (4) 100/1000Base-X SFP slots ports
+ (2) 1G/10GBase-X SFP+ slots
52V - 57 VDC or 100V - 250VAC
Op°onal Accessories
(sold separately)
SFP and SFP+ Modules
EDCA-DIO-01
Enclosure Door Contact Alarm
Industrial Power Supplies
(sold separately)
25104
Input: 85-264 VAC, 124-370 VDC
Output: 48 ~ 55 VDC, 5A, 240 Watts
25160
Input 90-264 VAC, 127-370 VDC
Output: 48 ~ 55 VDC, 10A, 480 Watts
SISPM1040-3166-L
This switch is a next generation rack mountable hardened
switch with 80Gbps switching capacity. It provides (16)
10/100/1000 PoE+ ports, (4) 100/1000 dual speeds SFP ports
and has (2) additional 1G/10G SFP+ slots.
(16) 10/100/1000Base-T PoE+ Ports + (4) 100/1000Base-X SFP Slots + (2) 1G/10GBase-X SFP+ Slots
Managed Hardened Gigabit Ethernet PoE+ Rack Mountable Switch
Specifications
Standards
IEEE 802.3
IEEE 802.3u
IEEE 802.3z
IEEE 802.3ae
IEEE 802.3x
IEEE 802.3ad
IEEE 802.1D
IEEE 802.1w
IEEE 802.1s
IEEE 802.1Q
IEEE 802.1p
IEEE 802.1ad
IEEE 802.1AB
IEEE 802.3af
IEEE 802.3at
IEEE 802.3az
IEEE 802.3ah
IEEE 802.1ag
IEC 62439-2
Protocols
CSMA/CD
Technology
Store-and-forward switching architecture
Connectors
(16)
10/
100/1000 Mbps RJ-45 ports
(4) 100/1000
Mbps
SFP slots
(2) 1G/10G SFP+ slots
(1) Console RJ-45 port
MAC Address
32K MAC address table
Backplane
80 Gbps
Digital Output
24 VDC / 1A (Relay)
Digital Input
Level 0 (low): 0V to 6V
Level 1 (high): 10V to 24V
Dimensions
Width: 17.4” [442 mm]
Depth: 11.81” [300 mm]
Height: 1.73” [44 mm]
Power Input
52 - 57VDC Dual Input Terminal Block or
Single Input 100 - 250VAC
Maximum Power Consumption (without PoE):
36 Watts
Power-over-Ethernet
Max PoE Budget 250 Watts (PoE power not
available with use of AC power supply)
15 Watts for (16) ports simultaneously
30 Watts for (8) ports simultaneously
Ingress Protection
IP30
Environment
Operating: -40°C to +75°C (1G SFPs)
Operating: -40°C to +60°C (10G SFPs)
Humidity: 5% to 95% (non-condensing)
Altitude: 0 – 10,000 ft.
Weight
10.58 lbs. [4.8 kg]
Certifications
FCC Class A; CE; NEMA TS-2, UL
Safety: LVD
Compliant
*
(Designed to Meet)
IEC61850-3, IEEE 1613, Class 1 Div 2
Warranty
5 Years
*
Please
contact sales
with certification needs
Features
IPv4/IPv6 dual protocols
Supports Jumbo Frame up to 9K
bytes
Authentication - RADIUS, TACACS+
DHCP Relay, DHCP Snooping, DHCP
Server
L2/L3/L4 ACLs Support MAC, VLAN
ID, or IP address, protocol, per port
LLDP (Link Layer Discovery Protocol)
ITU-T G.8031 Ethernet Linear
Protection
ITU-T G.8032 Ethernet Ring
Protection Switching
Rapid Ring for fast recovery
IEEE 802.3az Energy Efficiency
IP Source Guard, Port Security
Port Mirroring
Syslog
Static Routing, 130 rates (max)
Fanless Design
Media Redundancy Protocol (MRP)
Software Features
Management: Web Management,
SNMP V1/V2c/V3, SSH, CLI
Port Trunk: Supports IEEE 802.3ad port
trunk with link aggregation control
protocol (LACP) and static trunk
Multicast: Support IGMP Snooping V1/
V2/V3, MVR, MLD Snooping V1/V2
Quality of Service: Supports 8
hardware queues. Strict priority and
WRR, Ingress policer, Egress shaping
and per port rate control
Spanning Tree: Supports IEEE 802.1s
MSTP, IEEE 802.1w RSTP and IEEE
802.1D STP Compliant
VLAN: Port Based VLAN, IEEE
802.1Q tag-based, up to 4k VLAN
entries, Q-in-Q, MAC-based VLAN,
Management VLAN, Voice VLAN,
Private VLAN
Firmware Update through TFTP and
HTTP/HTTPs
E-Line, E-LAN, E-TREE, E-ACCESS, IEEE
802.3ah, IEEE 802.1ag, ITU-T Y.1731,
Y.1564
Support IEEE 1588 v2 PTP (TC)
PoE Features
Compliant with IEEE 802.3at PoE+
Compliant with IEEE 802.3af PoE
IEEE 802.1AB LLDP-MED
Configuration
PoE Configuration
PoE Scheduling
Power Delay
Auto Power Reset
DHCP per Port
Always on PoE
Device Management System
(DMS)
Graphical Monitoring – Topology
view, Floor view, Map view
Traffic Monitoring
Troubleshooting – Network
diagnostic, protection mechanism,
performance and link management
040822