Lantronix TN-10GSFP-LR8M-Cxx Series TN-10GSFP-xxx User Guide Rev E - Page 6

Lantronix TN-10GSFP-xxx User Guide Safety Instructions When a connector is removed during installation, testing, or servicing, or when an energized fiber is broken, a risk of ocular exposure to optical energy that may be potentially hazardous occurs, depending on the laser output power. The primary hazards of exposure to laser radiation from an optical-fiber system are: • Damage to the eye by accidental exposure to a beam emitted by a laser source. • Damage to the eye from viewing a connector attached to a broken fiber or an energized fiber. Danger: Never attempt to view optical connectors that might be emitting laser energy. Do not power up the laser product without connecting the laser to the optical fiber and putting the cover in position, as laser outputs will emit infrared laser light at this point. See the Lantronix SFP page for our full line of SFP transceivers. See the FOA webpage for additional information. High Risk Activities Disclaimer Components, units, or third-party products used in the product described herein are NOT fault-tolerant and are NOT designed, manufactured, or intended for use as on-line control equipment in the following hazardous environments requiring fail-safe controls: the operation of Nuclear Facilities, Aircraft Navigation or Aircraft Communication Systems, Air Traffic Control, Life Support, or Weapons Systems ("High Risk Activities"). Lantronix and its supplier(s) specifically disclaim any expressed or implied warranty of fitness for such High Risk Activities. SFP Unpacking Before you start installing the TN-10GSFP-xxx, verify that the package contains the following items: o One TN-10GSFP-xxx o Two protective foam pieces o One Documentation Postcard Notify your sales representative immediately if any of the above items are missing or damaged. Save the packaging for possible future use. SFP Installation Cautions • The SFP tranceiver module is keyed to only be installed one way. However, if forced the wrong way, damage may occur. • Avoid getting dust or other contaminants into the fiber bore of the SFP transceiver module, as this will cause the optics to not operate properly. • Clean the optic surfaces of the optical fiber before you plug them back in to the optical bores of another SFP transceiver module. See the Fiber Optic Association, Inc. Cleaning Fiber Optic Connections page on the FOA website for more information. 33485 Rev. E https://www.lantronix.com/ Page 6 of 15