Lantronix TN-SFP-LX8-Cxxx Series TN-SFP-xxx User Guide Rev G - Page 10

Lantronix TN-SFP-xxx User Guide SFP Information and SFP Detail Info Note: This feature is not available on all devices and may vary between products. See the related manual for more information. SFP Information This page displays general SFP information and monitoring information as shown and described below. Parameter descriptions: Parameter Port Tx Central Wavelength Bit rate Description The logical port for the settings contained in the same row. Displays the nominal transmitter output wavelength in nm. Displays the nominal bit rate of the transceiver. Temperature Displays the internally measured transceiver temperature. Temperature accuracy is vendor specific but must be better than 3 degrees Celsius over specified operating temperature and voltage. Displays the internally measured transceiver supply voltage. Accuracy is vendor specific but must be better than 3 percent of the manufacturer's nominal value over specified Vcc operating temperature and voltage. Note that in some transceivers, transmitter supply voltage and receiver supply voltage are isolated. In that case, only one supply is monitored. Refer to the device specification for more detail. Mon1 (Bias) Displays the measured TX bias current in uA. Accuracy is vendor specific but must be better than 10 percent of the manufacturer's nominal value over specified operating temperature and voltage. Mon2 (TX PWR) Displays the measured coupled TX output power in mW. Accuracy is vendor specific but must be better than 3dB over specified operating temperature and voltage. Data is 33477 Rev. G https://www.lantronix.com/ Page 10 of 15