Lantronix XPort Direct XPort Direct+ - Quick Start Guide - Page 6

Verification Check: If powered up correctly, the XPort Direct+ Demonstration Board power LED indicator lights blue and remains on. This LED is near the reset switch. What You Need to Know Hardware Address You need to know the unit's hardware address (also known as a MAC address). It is on the product label, in the format: 00-20-4a-XX-XX-XX, where the XXs are unique numbers/letters assigned to the product. Hardware Address: 00-20-4a IP Address Your XPort Direct+ must have a unique IP address on your network. The systems administrator generally provides the IP address, subnet mask, and gateway. The IP address must be within a valid range, unique to your network, and in the same subnet as your PC. IP Address Subnet Mask Gateway: You have several options for assigning an IP to your unit. We recommend that you connect the XPort Direct+ to the network and assign the IP address using DeviceInstaller software, which is on the product CD. For information on other methods, see the XPort Direct+ User Guide. Install DeviceInstaller 1. Open DeviceInstaller on the CD-ROM. If the CD does not launch automatically: a. Click the Start button on the Task Bar and select Run. b. Enter your CD drive letter, colon, backslash, Launch.exe (e.g., D:\Launch.exe). 2. Respond to the installation wizard prompts. Note: For more information about DeviceInstaller, see the DeviceInstaller online Help. Assign IP The unit's IP address is normally set to 0.0.0.0 at the factory. The hardware address is on the product label. The unit is DHCP enabled as the default. 1. Click StartÆPrograms Æ LantronixÆDeviceInstallerÆDeviceInstaller. If your PC has more than one network adapter, a message displays. Select an adapter and click OK. 4